Thermal oxidation improvement in semiconductor wafer fabrication
| Autor: | Mohd Nabil Muhtazaruddin, Abdul Yasser Abd Fatah, Mohd Effendi Amran, Nurul Aini Bani, Christopher Julian Mahandran, Hazilah Mad Kaidi |
|---|---|
| Rok vydání: | 2019 |
| Předmět: |
Thermal oxidation
Materials science Silicon wafer Silicon dioxide Design of experiments Oxide Energy Engineering and Power Technology Factorial experiment Instability Volumetric flow rate Wafer fabrication chemistry.chemical_compound chemistry Wafer Electrical and Electronic Engineering Composite material |
| Popis: | Thermal oxidation is a process done to grow a layer of oxide on the surface of a silicon wafer at elevated temperatures to form silicon dioxide. Usually, it en- counters instability in oxide growth and results in variation in the oxide thickness formed. This leads to downtime of furnace and wafer scrap. This study focuses on the factors leading to this phenomenon and finding the optimum settings of these factors. The factors that cause instability to oxide thickness were narrowed down to location of wafer in furnace, oxidation time, gas flow rate and temperature. Characterization and optimization were done using Design of Experiments. Full factorial design was implemented using 4 factors and 2 levels, resulting in 16 runs. Data analysis was done using Multiple Regression Analysis in JMP software. Actual versus predicted plot is examined to determine whether the model fit is significant. Adjusted R2 value was obtained at 99.8% or 0.998 indicating that there is very minimal variation of the data not explained by the model and thus confirming that the model is good. From the effect test, the factors were narrowed down from 4 factors to 3 factors. Location factor was found to have no impact. Significant factors that have impact are gas flow rate, oxidation time and temperature. Analyzing the leverage plots and least square mean plots, temperature was found to have the highest impact on oxide thickness. The model was further analyzed using prediction profiler in JMP to find the optimum settings for thermal oxidation process to meet the target oxide thickness of 8000A. Optimum setting for temperature was found to be at 958 C, gas flow rate at low flow rate (H2:6.5 slm and O2:4.5 slm), oxidation time at 280 min and location of wafers at both zone 1 and zone 2. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|