Fully inkjet printed SnO2 gas sensor on plastic substrate
Autor: | Rieu, Mathilde, camara, malick, Tournier, Guy, Viricelle, Jean-Paul, Pijolat, Christophe, De Rooij, Nicolaas F, Briand, Danick, Viricelle, J.P. |
---|---|
Přispěvatelé: | Laboratoire Georges Friedel (LGF-ENSMSE), Université de Lyon-Centre National de la Recherche Scientifique (CNRS)-École des Mines de Saint-Étienne (Mines Saint-Étienne MSE), Institut Mines-Télécom [Paris] (IMT)-Institut Mines-Télécom [Paris] (IMT), Procédés et REactivité des Systèmes Solide-gaz, Instrumentation et Capteurs (PRESSIC-ENSMSE), École des Mines de Saint-Étienne (Mines Saint-Étienne MSE), Institut Mines-Télécom [Paris] (IMT)-Institut Mines-Télécom [Paris] (IMT)-SPIN, Centre Sciences des Processus Industriels et Naturels (SPIN-ENSMSE), IMT Neuchâtel (IMT), Université de Neuchâtel (UNINE)-IMT, Sensors and Actuators and Microsystems Laboratory (SAMLAB), Institut of Microengineering (IMT), Ecole Polytechniqu fédérale de Lausanne (EPFL) |
Rok vydání: | 2016 |
Předmět: |
SnO2 sensor
Materials science Annealing (metallurgy) Sol-gel synthesis Nanotechnology 02 engineering and technology 01 natural sciences chemistry.chemical_compound Oxidizing agent Materials Chemistry Gold heater [SPI.GPROC]Engineering Sciences [physics]/Chemical and Process Engineering Electrical measurements Electrical and Electronic Engineering Instrumentation Inkwell Tin dioxide business.industry 010401 analytical chemistry Metals and Alloys 021001 nanoscience & nanotechnology Condensed Matter Physics Polyimide foil 0104 chemical sciences Surfaces Coatings and Films Electronic Optical and Magnetic Materials Inkjet printing Transducer chemistry Electrode Optoelectronics 0210 nano-technology business Carbon monoxide |
Zdroj: | Sensors and Actuators B: Chemical Sensors and Actuators B: Chemical, Elsevier, 2016, 236, pp.1091-1097. ⟨10.1016/j.snb.2016.06.042⟩ |
ISSN: | 0925-4005 |
Popis: | A tin dioxide (SnO2) sensor was fabricated by inkjet printing onto polyimide foil. Gold electrodes and heater were printed on each side of the substrate. A SnO2 based ink was developed by sol-gel method and jetted onto the electrodes. A final annealing at 400 degrees C compatible with the polymeric transducers allowed to synthetize the SnO2 sensing film. Electrical measurements were carried out to characterize the response of the fully printed sensors under oxidizing and reducing gases. The device was heated up at a temperature between 200 and 300 degrees C using the integrated heater. The proper operation of the full printed metal-oxide gas sensors was validated under exposure to carbon monoxide and nitrogen dioxide, in dry and wet air. (C) 2016 Elsevier B.V. All rights reserved. |
Databáze: | OpenAIRE |
Externí odkaz: |