Characterization of a Commercial Whey Protein Hydrolysate and Its Use as a Binding Agent in the Whey Protein Isolate Agglomeration Process
| Autor: | J. Amamcharla, N. Palmer, B. Zaitoun |
|---|---|
| Rok vydání: | 2020 |
| Předmět: |
Whey protein
Health (social science) biology Computer Networks and Communications Chemistry Economies of agglomeration Plant Science Health Professions (miscellaneous) Microbiology Hydrolysate Whey protein isolate Hardware and Architecture Scientific method biology.protein Food science agglomeration whey hydrolysate isolate Software Food Science |
| Zdroj: | Foods; Volume 11; Issue 12; Pages: 1797 |
| ISSN: | 2378-5977 |
| DOI: | 10.4148/2378-5977.8056 |
| Popis: | The first objective of this study was to characterize the chemical properties of three lots of whey protein hydrolysate (WPH) obtained from a commercial manufacturer. The degree of hydrolysis (DH) of WPH was between 13.82 and 15.35%, and was not significantly (p > 0.05) different between the batches. From MALDI-TOF, 10 to 13 different peptides were observed in the range of 2.5–5 kDa and 5–8 kDa, respectively. The second objective of the study was to evaluate the effectiveness of WPH as a binder in whey protein isolate (WPI) wet agglomeration. For this purpose, a 3 × 3 × 2 factorial design was conducted with pre-wet mass (60, 100, and 140 g), WPH concentration (15, 20, and 25%), and flow rate (4.0 and 5.6 mL·min−1) as independent variables. WPI agglomeration was carried out in a top-spray fluid bed granulator (Midi-Glatt, Binzen, Germany). Agglomerated WPI samples were stored at 25 °C and analyzed for moisture content (MC), water activity, relative dissolution index (RDI), and emulsifying capacity. Pre-wet mass, flow rate, and the WPH concentration had a significant (p < 0.05) effect on the MC. Moreover, all interactions among the main effects had also a significant (p < 0.05) effect on MC. High MC and water activity were observed for the treatments with a higher pre-wet volume and higher flow rate, which also resulted in clumping of the powders. The treatment with the 60 g pre-wet mass, 20% WPH concentration, and 5.6 mL·min−1 flow rate combination had the highest RDI among all the samples. In conclusion, WPH can be used as a potential alternative to soy lecithin in WPI wet agglomeration. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|