Advanced Workflows for Fluid Transfer in Faulted Basins
| Autor: | Françoise Willien, Muriel Thibaut, Xavier Guichet, Anne Jardin, Isabelle Faille |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2014 |
| Předmět: |
General Chemical Engineering
Energy Engineering and Power Technology Slip (materials science) Structural basin lcsh:Chemical technology lcsh:HD9502-9502.5 lcsh:Energy industries. Energy policy. Fuel trade Unstructured grid Overpressure Permeability (earth sciences) Tectonics Fuel Technology Basin modelling Fluid dynamics Geotechnical engineering lcsh:TP1-1185 Petrology Geology |
| Zdroj: | Oil & Gas Science and Technology, Vol 69, Iss 4, Pp 573-584 (2014) |
| ISSN: | 1953-8189 1294-4475 |
| Popis: | The traditional 3D basin modeling workflow is made of the following steps: construction of present day basin architecture, reconstruction of the structural evolution through time, together with fluid flow simulation and heat transfers. In this case, the forward simulation is limited to basin architecture, mainly controlled by erosion, sedimentation and vertical compaction. The tectonic deformation is limited to vertical slip along faults. Fault properties are modeled as vertical shear zones along which rock permeability is adjusted to enhance fluid flow or prevent flow to escape. For basins having experienced a more complex tectonic history, this approach is over-simplified. It fails in understanding and representing fluid flow paths due to structural evolution of the basin. This impacts overpressure build-up, and petroleum resources location. Over the past years, a new 3D basin forward code has been developed in IFP Energies nouvelles that is based on a cell centered finite volume discretization which preserves mass on an unstructured grid and describes the various changes in geometry and topology of a basin through time. At the same time, 3D restoration tools based on geomechanical principles of strain minimization were made available that offer a structural scenario at a discrete number of deformation stages of the basin. In this paper, we present workflows integrating these different innovative tools on complex faulted basin architectures where complex means moderate lateral as well as vertical deformation coupled with dynamic fault property modeling. Two synthetic case studies inspired by real basins have been used to illustrate how to apply the workflow, where the difficulties in the workflows are, and what the added value is compared with previous basin modeling approaches. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|