Influence of Leading-Edge Geometry on Profile Losses in Turbines at Off-Design Incidence: Experimental Results and an Improved Correlation
| Autor: | S. A. Sjolander, M. W. Benner, S. H. Moustapha |
|---|---|
| Rok vydání: | 1997 |
| Předmět: | |
| Zdroj: | Journal of Turbomachinery. 119:193-200 |
| ISSN: | 1528-8900 0889-504X |
| DOI: | 10.1115/1.2841101 |
| Popis: | The most recent correlations for turbine profile losses at off-design incidence include the leading-edge diameter as the only aspect of the leading-edge geometry which influences the losses. Cascade measurements are presented for two turbine blades which differ primarily in their leading-edge geometries. The incidence was varied over a range of ±20 degrees and the results show significant discrepancies between the observed profile losses and those predicted by the available correlations. Using data from the present experiments, as well as cases from the literature for which sufficient geometric data are given, a revised correlation has been developed. The new correlation is a function of both the leading-edge diameter and the wedge angle, and it is significantly more successful than the existing correlations. It is argued that the off-design loss behaviour of the blade is influenced by the magnitude of the discontinuity in curvature at the points where the leading-edge circle meets the rest of the blade profile. The wedge angle appears to be an approximate and convenient measure of the discontinuity in curvature at these blend points.Copyright © 1995 by ASME |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|