Porous Particles Drying In A Vertical Upward Pneumatic Conveying Dryer

Autor: Samy M. El-Behery, W. A. El-Askary, K. A. Ibrahim, Mofreh H. Hamed
Jazyk: angličtina
Rok vydání: 2009
Předmět:
ISSN: 1323-1340
DOI: 10.5281/zenodo.1062677
Popis: A steady two-phase flow model has been developed to simulate the drying process of porous particle in a pneumatic conveying dryer. The model takes into account the momentum, heat and mass transfer between the continuous phase and the dispersed phase. A single particle model was employed to calculate the evaporation rate. In this model the pore structure is simplified to allow the dominant evaporation mechanism to be readily identified at all points within the duct. The predominant mechanism at any time depends upon the pressure, temperature and the diameter of pore from which evaporating is occurring. The model was validated against experimental studies of pneumatic transport at low and high speeds as well as pneumatic drying. The effects of operating conditions on the dryer parameters are studied numerically. The present results show that the drying rate is enhanced as the inlet gas temperature and the gas flow rate increase and as the solid mass flow rate deceases. The present results also demonstrate the necessity of measuring the inlet gas velocity or the solid concentration in any experimental analysis.
{"references":["Baeyens J., Gauwbergen D. V. and Vinckier I., 1995, \"Pneumatic\nDrying: the Use of Large-Scale Data in a Design Procedure\", Powder\nTech., Vol. 83, pp. 139-148.","Borde I. and Levy A., 2006, \"Pneumatic and Flash Drying\", in\nHandbook of Industrial Drying, 3rd Ed., (Mujumdar A. S. Ed.), CRC\nPress, New York.","Moyers C. G. and Baldwin G. W., 1997, \"Psychrometry, Evaporative\nCooling, and Solids Drying\", in Perry-s Chemical Engineers- Handbook,\n7th Ed. (Eds. Robert H. Perry R. H., Green D. W. and Maloney J. O.),\nMcGraw-Hill, Inc.","Thorpe G.R., Wint A. and Coggan G.C., 1973, \"The Mathematical\nModelling of Industrial Pneumatic Driers\", Transactions of the\nInstitution of Chemical Engineers, Vol. 51, pp. 339-348.","Kemp I. C., Bahu R. E. and Pasley H. S., 1994, \"Model Development\nand Experimental Studies of Vertical Pneumatic Conveying Dryers\",\nDrying Tech., Vol. 12, pp. 1323-1340.","Kemp I. C and Oakley D. E., 1997, \"Simulation and Scale-up of\nPneumatic Conveying and Cascading Rotary Dryers\", Drying Tech.,\nVol. 15, pp. 1699-1710.","Kemp I. C., Oakley D. E. and Bahu R. E., 1991, \"Computational Fluid\nDynamics Modelling of Vertical Pneumatic Conveying Dryers\", Powder\nTech., Vol. 65, pp. 477-484.","Radford R. D., 1997, \"A Model of Particulate Drying in Pneumatic\nConveying Systems\", Powder Tech., Vol. 93, pp. 109-126.","Levy A. and Borde I., 1999, \"Steady State One Dimensional Flow Model\nfor a Pneumatic Dryer\", Chem. Eng. Processing, Vol. 38, pp. 121-130.\n[10] Skuratovsky I., Levy A. and Borde I., 2003, \"Two-Fluid Two-\nDimensional Model for Pneumatic Drying\", Drying Tech., Vol. 21, pp.\n1645-1668.\n[11] Skuratovsky I., Levy A. and Borde I., 2005, \"Two-Dimensional\nNumerical Simulations of the Pneumatic Drying in Vertical pipes\",\nChem. Eng. Processing, Vol. 44, pp. 187-192.\n[12] Pelegrina A. H. and Crapiste G. H., 2001, \"Modelling the Pneumatic\nDrying of Food Particles\", J. Food Eng., Vol. 48, pp. 301-310.\n[13] Narimatsu C. P., Ferreira M. C. and Feire J. T., 2007, \"Drying of Coarse\nParticles in a Vertical Pneumatic Conveyor\", Drying Tech., Vol. 25, pp.\n291-302.\n[14] Fyhr C. and Rasmuson A., 1997, \"Mathematical Model of Pneumatic\nConveying Dryer\", AICHE Journal, Vol. 43, pp. 2889-2902.\n[15] Fyhr C. and Rasmuson A., 1997, \"Steam Drying of Wood Ships in\nPneumatic Conveying Dryers\", Drying Tech., Vol. 15, pp. 1775-1785.\n[16] Alvarez P. I., Vega R. and Blasco R., 2005, \"Cocurrent Downflow\nFluidized Bed Dryer: Experimental Equipment and Modeling\", Drying\nTech., Vol. 23, pp. 1435-1449.\n[17] NamKung W. and Cho M., 2004, \"Pneumatic Drying of Iron Ore\nparticles in a Vertical tube\", Drying Tech., Vol. 22, pp. 877-891.\n[18] Kaensup W., Kulwong S. and Wongwises S., 2006, \"A Small-Scale\nPneumatic Conveying Dryer of Rough Rice\", Drying Tech., Vol. 24, pp.\n105-113.\n[19] Kaensup W., Kulwong S. and Wongwises S., 2006, \"Comparison of\nDrying Kinetics of Paddy Using a Pneumatic Dryer with and without a\nCyclone\", Drying Tech., Vol. 24, pp. 1039-1045.\n[20] Hamed M. H., 2005,\" Choked Gas-Solid Two-Phase Flow in Pipes\", J.\nEng. Applied Science, Faculty of Engineering, Cairo University, Vol.\n52, pp. 961-980.\n[21] Kladas, D. D. and Deorgiou, D. P., 1993, \"A Relative Examination of\nCD-Re Relationships used in Particle Trajectory Calculations\", Trans.\nof ASME, J. of Fluids Engineering, Vol. 115, pp. 162-165.\n[22] Han, T., A. Levy, and Y. Peng, 2000, \"Model for Dilute Gas-Particle\nFlow in Constant-Area Lance with Heating and Friction \", Powder\nTechnology, Vol. 112, pp. 283-288.\n[23] Debrand S., 1974, \"Heat Transfer during a Flash Drying Process\", Ind.\nEng. Chem., Process Des. Develop., Vol. 13, pp. 396-404.\n[24] Welty J. R., Wicks G. E. and Wilson R. E., 1984, \"Fundamentals of\nMomentum, Heat, and Mass Transfer\", 3rd Ed., John Wiley & Sons,\nNew York.\n[25] Reynolds W. C., 1979, \"Thermodynamic Properties in SI: Graphs,\nTables and Computational Equations for Forty Substances\", Published\nby the Department of Mechanical Engineering, Stanford University,\nStanford CA 94305.\n[26] Crowe C., Sommerfeld M. and Tsuji Y., 1998, \"Multiphase Flow with\nDroplets and Particles\", CRC Press, Florida, USA.\n[27] Hariu O. H. and Molstad M. C., 194, \"Pressure Drop in Vertical Tubes\nin Transport of Solids by Gases\", Industrial and Engineering Chemistry,\nVol. 41, pp. 1148-1160.\n[28] Arastoopour H. and Gidaspow D., 1979, \"Vertical Pneumatic Conveying\nUsing Four Hydrodynamic Models\", Ind. Eng. Chem. Fundam., Vol. 18,\npp. 123-130.\n[29] Mobbs F. R., Bowers H. M., D. M. Riches D. M., and Cole B. N., 1969-\n70, \"Influence of Particle Size Distribution on the high-Speed flow of\nGas-Solid Suspensions in a Pipe\", Proc Instn Mech Engrs, Vol. 184, Pt\n3C, paper 9.\n[30] Bunyawanichakul P., Walker G. J., Sargison J. E. and Doe P. E., 2007,\n\"Modelling and Simulation of Paddy Grain (Rice) Drying in a simple\nPneumatic Dryer\", Biosystems Eng., Vol. 96, pp. 335-344.\n[31] Saravanan B., Balsubramaniam N. and Srinivasakannan C., 2007,\n\"Drying Kinetics in a Vertical Gas-Solid System\", Chem. Eng. Tech.,\nVol. 30, pp. 176-183."]}
Databáze: OpenAIRE
Externí odkaz: