| Popis: |
This study investigates the influence of various inducer configurations upstream of a pump impeller on the single and two-phase flow performance. Three pitch values (P = 0.151, 0.251, and 0.351 m), as well as three different numbers of blades (N = 2, 3, and 4 blades), were studied, leading to a total of 9 different inducer geometries. The main objective of the present study is to analyze and compare the corresponding performances and the two-phase mixing behavior, which is necessary for improving the two-phase pumping ability. 3D steady-state simulations using the Moving Reference Frame (MRF) approach were applied for single-phase flow, while a transient setup using a moving-mesh approach was employed for two-phase simulations. Turbulence was modeled by the Reynolds Stress Model (RSM), whereas the Volume of Fluid (VOF) method was applied to model air-water interactions. The results show that the increase in the number of blades leads to a high performance drop at overload (high-flow) conditions, but only to a slight performance enhancement at part-load (low-flow) conditions. Additionally, the effective flow range of the inducer corresponding to high efficiency becomes narrower for a higher number of blades. Concerning the inducer pitch, at part-load conditions, a lower pitch is slightly beneficial to smoothly suck the flow and damp the low-flow vortices; employing a high pitch at these conditions results in intensified flow vortices, reducing slightly the performance. On the other hand, the blade pitch is very influential for the performance at optimal and overload conditions, where a lower pitch causes flow blockage, leading to significant performance deterioration and a very limited range of applications. Generally, it was found that a modification of the inducer configuration affects the performance much more at overload compared to part-load conditions. Concerning two-phase mixing performance, the highest pitch provides the best mixing since the inducer is able to effectively churn the two phases. Similarly, an increase in the number of blades amplifies the turbulence between the two phases, thus improving mixing. Overall, a higher inducer pitch and a low to moderate number of inducer blades best ensure high performance, wide working range, and efficient two-phase mixing. |
