Current variability in the assessment of component position for the unhappy knee replacement
Autor: | Andrew M. Suchowersky, David Dickison, L. A. Ashton |
---|---|
Rok vydání: | 2019 |
Předmět: |
medicine.medical_specialty
Knee Joint Standardization medicine.medical_treatment Pain Knee replacement Computed tomography 03 medical and health sciences 0302 clinical medicine Component (UML) medicine Humans Sampling (medicine) Medical physics Arthroplasty Replacement Knee Component placement Protocol (science) medicine.diagnostic_test business.industry Australia General Medicine Radiography surgical procedures operative 030220 oncology & carcinogenesis Position (finance) 030211 gastroenterology & hepatology Surgery Knee Prosthesis Tomography X-Ray Computed business |
Zdroj: | ANZ Journal of Surgery. 90:1246-1252 |
ISSN: | 1445-2197 1445-1433 |
DOI: | 10.1111/ans.15476 |
Popis: | INTRODUCTION Total knee arthroplasty (TKA) has a success rate of 80-90%, but despite this encouraging figure a painful TKA can be a source of dismay for patients and surgeons. Computed tomography (CT) scan has been developed as a tool to collect data in the analysis of TKA component placement. Protocols used to collect such data exist in orthopaedic and radiology practice with little standardization and significant variation. The aim of this review article was to evaluate such variability by sampling a series of protocols from a range of different radiology practices within NSW, Australia in a case-based manner and to then compare them against any literature standards. METHODS The literature was surveyed for existing CT scan protocols used in TKA assessment. These were then compared with a series of metropolitan and rural radiology firms across the public and private sectors in NSW, Australia. RESULTS Considerable variability exists between current protocols across NSW, Australia, which differ with proposed literature standards. CONCLUSION Variabilities encountered when comparing the different scanning protocols in use for the assessment of TKA constitute a large potential source of error in the analysis of TKA component positioning. The reliance surgeons place on such analyses suggests the need for an established scanning protocol with an incorporated grading system and standardized values to allow reproducible data to help assess and predict TKA function. |
Databáze: | OpenAIRE |
Externí odkaz: |