Comparative studies on the mechanical properties and microstructures of outerwood and corewood in Pinus radiata D. Don
| Autor: | Mingyue Li, Yong-dong Zhou, Yingchun Gong, Yu-rong Wang, Haiqing Ren |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2021 |
| Předmět: |
Pinus radiata
Building construction Materials science biology Young's modulus Mechanical properties Forestry SD1-669.5 biology.organism_classification Microstructure Biomaterials symbols.namesake Crystallinity Compressive strength Flexural strength Tracheid Corewood symbols Microfibril Outerwood Composite material Microstructures TH1-9745 |
| Zdroj: | Journal of Wood Science, Vol 67, Iss 1, Pp 1-9 (2021) |
| ISSN: | 1611-4663 1435-0211 |
| Popis: | Twenty-year-old Pinus radiata trees imported from New Zealand were investigated, and a comparison was made between the outerwood (rings 16–20) and corewood (rings 4–6) in terms of mechanical properties, anatomical characteristics, microfibril angle (MFA), relative crystallinity, crystallite size and lignin content to determine the relationship between their mechanical properties and microstructures. The results demonstrated that the mechanical properties of the Pinus radiata outerwood were significantly better than those of the corewood. The outerwood had a modulus of rupture (MOR) of 106 MPa, a modulus of elasticity (MOE) of 11.4 GPa, and compressive strength parallel to the grain of 38.7 MPa, and the MOR, MOE and compressive strength parallel to the grain of the corewood were 78.9 MPa, 7.12 GPa and 29.3 MPa, respectively. The observed microstructures of the Pinus radiata outerwood and corewood were different, mainly due to differences in cell wall thickness, MFA, and relative crystallinity. The double wall thickness of the tracheid cells of the corewood and outerwood were 3.65 and 5.02 µm, respectively. The MFA data indicated that the average MFA of the outerwood was 14.0°, which was smaller than that of the corewood (22.3°). With X-ray diffraction, the relative crystallinity of the corewood was determined to be 35.7%, while that of the outerwood was 40.2%. However, the crystallite size of the outerwood cell wall shows no obvious difference from that of the corewood. Imaging FTIR spectroscopy showed a slightly higher relative content of lignin in the cell wall of the outerwood. The correlation between the microstructures and mechanical properties showed that the corewood with a thin cell wall, large MFA and low relative crystallinity had poor mechanical properties, while the outerwood with a thicker tracheid, smaller MFA and higher relative crystallinity had better mechanical properties. This means that the MFA, relative crystallinity and cell wall thickness synergically affect the mechanical properties of Pinus radiata in different radial locations. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full text from SpringerLink