Oscillating wire arc additive manufacture of rocket motor bimetallic conical shell

Autor: Bo Zheng, Shengfu Yu, RunZhen Yu, Tianying He
Rok vydání: 2022
Předmět:
Zdroj: The International Journal of Advanced Manufacturing Technology. 119:6601-6612
ISSN: 1433-3015
0268-3768
DOI: 10.1007/s00170-021-08477-2
Popis: This paper studies the temperature field, dynamic strain and forming accuracy of the Oscillate-WAAM conical shell in the forming process and manufactures the WAAM conical shell part. The results show that compared with the offset filling WAAM, the oscillate-WAAM conical shell shows the following characteristics：the temperature difference value between the inner and outer walls of the shell is significantly reduced, the cooling rate doubled decreased, the interlayer temperature is above 300°C, as well as the average temperature gradient, the dynamic strain stability value and deformation are reduced by about 50%. Under the same process parameters, the travel speed of Oscillate-WAAM is low, which increased the heat input large and the interlayer temperature high. Meanwhile, the molten pool of Oscillate-WAAM is in consistent with the width of the shell. The molten pool simultaneous solidifying changes the stress state of printed shell form three-dimensional to two-dimensional. All above are conductive to stress release, and reduce the strain and deformation of components. The bimetallic rocket motor shell composed of HS600 and HS950 is manufactured by oscillate-WAAM. The section roundness of the shell is 0.31mm and the overall forming accuracy is ±0.625mm. The deposited metal in HS600 part of conical shell is composed of pearlite and pro-eutectoid ferrite. While the deposited metal of HS950 is composed of pearlite, acicular ferrite and bainite. The forming accuracy and mechanical properties of conical shell formed by Oscillate-WAAM meet the requirements.
Databáze: OpenAIRE
Externí odkaz:
Nepřihlášeným uživatelům se plný text nezobrazuje