The poisoning level of Pt/C catalysts used in PEM fuel cells by the hydrogen feed gas impurities: The bonding strength
| Autor: | Aline Auroux, G. Postole |
|---|---|
| Přispěvatelé: | Institut de recherches sur la catalyse et l'environnement de Lyon (IRCELYON), Université Claude Bernard Lyon 1 (UCBL), Université de Lyon-Université de Lyon-Centre National de la Recherche Scientifique (CNRS)-Institut de Chimie du CNRS (INC) |
| Rok vydání: | 2011 |
| Předmět: |
inorganic chemicals
Isothermal microcalorimetry Hydrogen Inorganic chemistry Energy Engineering and Power Technology Proton exchange membrane fuel cell chemistry.chemical_element 02 engineering and technology 010402 general chemistry 7. Clean energy 01 natural sciences Catalysis chemistry.chemical_compound Ammonia Adsorption Renewable Energy Sustainability and the Environment Chemistry [CHIM.CATA]Chemical Sciences/Catalysis 021001 nanoscience & nanotechnology Condensed Matter Physics [SDE.ES]Environmental Sciences/Environmental and Society 0104 chemical sciences Fuel Technology 13. Climate action 0210 nano-technology Platinum Carbon monoxide Nuclear chemistry |
| Zdroj: | International Journal of Hydrogen Energy International Journal of Hydrogen Energy, Elsevier, 2011, 36, pp.6817-6825. ⟨10.1016/j.ijhydene.2011.03.018⟩ |
| ISSN: | 0360-3199 |
| DOI: | 10.1016/j.ijhydene.2011.03.018 |
| Popis: | 11 Postole, Georgeta Auroux, Aline; Proton exchange membrane fuel cells (PEMFCs) most likely will us reformed fuel as the primary source for the anode feed despite it nearly always contains carbon monoxide or ammonia. In this paper, the microcalorimetry technique was employed to study and compare the poisoning effect of pollutants such as CO and NH3 on three commercial carbon-supported platinum catalysts with high Pt loading, aimed to be used in PEMFCs applications. Microcalorimetric measurements were performed at 80 degrees C and the results were compared with those obtained from hydrogen adsorption in similar conditions. All the catalysts exhibited significantly higher differential heats of CO adsorption in comparison with NH3 and hydrogen adsorption, indicating that carbon monoxide will be primarily adsorbed in case of co-adsorption, while ammonia and hydrogen will compete in the adsorption process on the same type of active sites. The irreversibly (chemically) amount of adsorbed molecules on Pt/C surfaces decreases in the order: CO >> NH3 > H-2. Copyright (C) 2011, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect