Correlation of Residual Stresses and Coating Properties in Arc-Sprayed Coatings on Different Substrates for Maritime Applications
| Autor: | Knuth-Michael Henkel, Werner Kroemmer, Michél Hauer, Sebastian Krebs |
|---|---|
| Přispěvatelé: | Publica |
| Jazyk: | angličtina |
| Rok vydání: | 2020 |
| Předmět: |
Hole drilling method
Materials science Propeller 02 engineering and technology engineering.material 021001 nanoscience & nanotechnology Condensed Matter Physics Surfaces Coatings and Films Corrosion 020303 mechanical engineering & transports 0203 mechanical engineering Coating Residual stress Electronic speckle pattern interferometry Ultimate tensile strength Materials Chemistry engineering Bronze Composite material 0210 nano-technology |
| Popis: | Arc spraying is a cost-effective technology, which is determined by a few key factors. It is already established for corrosion protection of large structures and thus considered for restoration of eroded ship rudders and propellers by depositing typical propeller materials. The main parameters like arc current, gas type/flow or process kinematics strongly influence the residual stresses in these coatings, which in turn affect coating properties. In past investigations, it was shown that this impact could be modified by using alternative gas mixtures or changing the heat input in the process. However, the mentioned studies neglect the influence of the substrate, since solely steel substrates were used. In consequence, propeller alloys CuAl9Ni5Fe4Mn (Ni-Al bronze) and CuMn13Al8Fe3Ni2 (Mn-Al bronze) were now arc-sprayed onto bronze substrates while using the same parameters and kinematics as in the past. For reproducible results, the residual stresses within the coatings were measured by novel incremental hole drilling method based on electronic speckle pattern interferometry (ESPI) and correlated with the other coating properties. In comparison with spraying onto steel, the same conditions led to reduced Young’s moduli, lower tensile stresses and improved cavitation erosion resistance, while other properties like hardness and electrical conductivity showed varying trends. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|