Measurement of Ultrafine Particle Size Distributions from Coal-, Oil-, and Gas-Fired Stationary Combustion Sources
| Autor: | Glenn C. England, M.-C. Oliver Chang, John G. Watson, Philip K. Hopke, Seung-Muk Yi, Judith C. Chow |
|---|---|
| Rok vydání: | 2004 |
| Předmět: |
Aerosols
Air Pollutants Particle number Chemistry Analytical chemistry Mineralogy Incineration Management Monitoring Policy and Law Combustion medicine.disease_cause Soot Dilution Diffusion Coal Petroleum Scanning mobility particle sizer Ultrafine particle medicine Particle Gases Particle size Particle Size Waste Management and Disposal Environmental Monitoring |
| Zdroj: | Journal of the Air & Waste Management Association. 54:1494-1505 |
| ISSN: | 2162-2906 1096-2247 |
| DOI: | 10.1080/10473289.2004.10471010 |
| Popis: | Currently, we have limited knowledge of the physical and chemical properties of emitted primary combustion aerosols and the changes in those properties caused by nucleation, condensation growth of volatile species, and particle coagulations under dilution and cooling in the ambient air. A dilution chamber was deployed to sample exhaust from a pilot-scale furnace burning various fuels at a nominal heat input rate of 160 kW/h(-1) and 3% excess oxygen. The formation mechanisms of particles smaller than 420 nm in electrical mobility diameter were experimentally investigated by measurement with a Scanning Mobility Particle Sizer (SMPS) as a function of aging times, dilution air ratios, combustion exhaust temperatures, and fuel types. Particle formation in the dilution process is a complex mixture of nucleation, coagulation, and condensational growth, depending on the concentrations of available condensable species and solid or liquid particles (such as soot, ash) in combustion exhausts. The measured particle size distributions in number concentrations measured show peaks of particle number concentrations for medium sulfur bituminous coal, No. 6 fuel oil, and natural gas at 40-50 nm, 70-100 nm, and 15-25 nm, respectively. For No. 6 fuel oil and coal, the particle number concentration is constant in the range of a dilution air ratio of 50, but the number decreases as the dilution air ratio decreases to 10. However, for natural gas, the particle number concentration is higher at a dilution air ratio of 10 and decreases at dilution air ratios of 20-50. At a dilution air ratio of 10, severe particle coagulation occurs in a relatively short time. Samples taken at different combustion exhaust temperatures for these fuel types show higher particle number concentrations at 645 K than at 450 K. As the aging time of particles increases, the particles increase in size and the number concentrations decrease. The largest gradient of particle number distribution occurs within the first 10 sec after dilution but shows only minor differences between 10 and 80 sec. The lifetimes of the ultrafine particles are relatively short, with a scale on the order of a few seconds. Results from this study suggest that an aging time of 10 sec and a dilution air ratio of 20 are sufficient to obtain representative primary particle emission samples from stationary combustion sources. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|