Methodology for high accuracy contact angle measurement
| Autor: | Robert David, Ali Kalantarian, A. W. Neumann |
|---|---|
| Rok vydání: | 2009 |
| Předmět: |
business.industry
Capillary action Drop (liquid) Rotational symmetry Image processing Surfaces and Interfaces Condensed Matter Physics Subpixel rendering Contact angle Surface tension chemistry.chemical_compound Optics chemistry Electrochemistry Fluoropolymer General Materials Science business Spectroscopy |
| Zdroj: | Langmuir : the ACS journal of surfaces and colloids. 25(24) |
| ISSN: | 1520-5827 |
| Popis: | A new version of axisymmetric drop shape analysis (ADSA) called ADSA-NA (ADSA-no apex) was developed for measuring interfacial properties for drop configurations without an apex. ADSA-NA facilitates contact angle measurements on drops with a capillary protruding into the drop. Thus a much simpler experimental setup, not involving formation of a complete drop from below through a hole in the test surface, may be used. The contact angles of long-chained alkanes on a commercial fluoropolymer, Teflon AF 1600, were measured using the new method. A new numerical scheme was incorporated into the image processing to improve the location of the contact points of the liquid meniscus with the solid substrate to subpixel resolution. The images acquired in the experiments were also analyzed by a different drop shape technique called theoretical image fitting analysis-axisymmetric interfaces (TIFA-AI). The results were compared with literature values obtained by means of the standard ADSA for sessile drops with the apex. Comparison of the results from ADSA-NA with those from TIFA-AI and ADSA reveals that, with different numerical strategies and experimental setups, contact angles can be measured with an accuracy of less than 0.2 degrees. Contact angles and surface tensions measured from drops with no apex, i.e., by means of ADSA-NA and TIFA-AI, were considerably less scattered than those from complete drops with apex. ADSA-NA was also used to explore sources of improvement in contact angle resolution. It was found that using an accurate value of surface tension as an input enhances the accuracy of contact angle measurements. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|