Effect of Al, Ti and C additions on Widmanstätten microstructures and mechanical properties of cast Al0.6CoCrFeNi compositionally complex alloys
Autor: | Ulrike Hecht, Oleg Stryzhyboroda, Aleksander Kostka, Alex Asabre, Janine Pfetzing-Micklich, Guillaume Laplanche |
---|---|
Jazyk: | angličtina |
Rok vydání: | 2019 |
Předmět: |
Materials science
Mechanical Engineering Alloy High density 02 engineering and technology engineering.material 010402 general chemistry 021001 nanoscience & nanotechnology Microstructure 01 natural sciences 0104 chemical sciences Mechanics of Materials Phase (matter) engineering lcsh:TA401-492 General Materials Science Grain boundary lcsh:Materials of engineering and construction. Mechanics of materials Composite material 0210 nano-technology Ductility Grain Boundary Sliding |
Zdroj: | Materials & Design, Vol 184, Iss, Pp-(2019) |
ISSN: | 0264-1275 |
Popis: | The cast microstructure of the Al0.6CoCrFeNi compositionally complex alloy was successfully refined with small additions of Al, Ti and C and its mechanical properties were optimized. In the as-cast state, this alloy has a Widmanstätten microstructure with coarse grains (∼110 μm) of a strong BCC/B2 matrix and soft FCC plates (∼65 vol.%) with large widths (∼1.3 μm). The addition of 0.25 at.% C to Al0.6CoCrFeNi stabilizes the FCC phase and favors the formation of a coarse dendritic microstructure making this alloy unsuitable for structural applications. In contrast, alloying of either 3 at.% Al, Ti, or 3% Ti and 0.25% C to Al0.6CoCrFeNi refined its Widmanstätten microstructure, i.e. the thickness of the FCC plates and/or the size of the prior BCC/B2 grains were significantly reduced. As a result of these microstructural changes, Al and Ti containing alloys show an outstanding strength (twice higher than that of Al0.6CoCrFeNi) and ductilities ≤5% at 20 °C. These properties are retained at 400 °C but at 700 °C, the strength and ductility of almost all alloys decrease. However, Ti containing alloys exhibit much larger ductilities (∼50%) at 700 °C due to their high density of grain boundaries which accommodate plastic deformation through grain boundary sliding. Keywords: High-entropy alloys, Microalloying, Microstructural refinement, Grain boundary sliding, Tensile properties, Fracture surfaces |
Databáze: | OpenAIRE |
Externí odkaz: |