Looking into a laser textured piston ring-liner contact
Autor: | Arup Gangopadhyay, Tom Reddyhoff, Khizer Tufail, Alessandra Ciniero, Sorin-Cristian Vladescu |
---|---|
Přispěvatelé: | Ford Motor Company |
Rok vydání: | 2017 |
Předmět: |
Technology
Friction reduction Engineering drawing Materials science Piston rings 02 engineering and technology MECHANISMS law.invention Cylinder (engine) Laser surface texture Piston Reciprocating motion Engineering 0203 mechanical engineering law HYDRODYNAMIC LUBRICATION Mechanical Engineering & Transports Stroke (engine) Piston ring Lubricant Composite material Cavitation Science & Technology Mechanical Engineering FRICTION Surfaces and Interfaces PERFORMANCE INLET SUCTION 021001 nanoscience & nanotechnology 0910 Manufacturing Engineering Surfaces Coatings and Films Engineering Mechanical WEAR 020303 mechanical engineering & transports Starvation Mechanics of Materials STEEL SURFACES Lubrication 0210 nano-technology Contact area SURFACE TEXTURES FILM 0913 Mechanical Engineering |
Zdroj: | Tribology International. 115:140-153 |
ISSN: | 0301-679X |
Popis: | This paper presents an experimental study into the flow behaviour of lubricant in a reciprocating contact simulating a piston ring–cylinder liner pair. The aim was to understand the effects of cavitation, starvation and surface texture, as well as the interaction between these, in order to improve automotive engine performance. A custom-built test rig was used, in which a section of piston ring is loaded against a reciprocating, laser-textured, fused silica pad representing the liner. A fluorescence microscope focusses through the silica specimen onto the contact in order to image the distribution of dyed oil. Tests were performed using a range of texture geometries and orientations, under starved and fully-flooded lubrication conditions, with measurements being compared against those from a non-textured reference. Under limited oil supply conditions, the non-textured reciprocating contact sweeps oil towards the reversal points (TDC and BDC), leading to starvation and increased friction. This issue is alleviated by the presence of surface texturing, with each pocket transferring oil from the inlet to the outlet of the contact as it passes; the result being 33% lower friction and oil distributed evenly over the liner surface. Even under fully flooded conditions, starvation is shown to occur following each reversal, as the change in sliding direction causes the cavitated outlet to become the oil-deprived inlet. This proof of cavitation-reversal-starvation, which occurs for up to the first 5% of the stroke length, depending on the lubricant’s viscosity, corresponds to regions of high wear, measured in this study and on actual cylinder liners reported in the literature. This process is also counteracted by the presence of surface texture, with each pocket depositing oil into the cavitated region prior to reversal. Fluorescence data also provides insights into other mechanisms with which different textures geometries control friction. Grooves oriented parallel to sliding direction increase friction as they appear to connect the high pressure inlet with the low pressure outlet, leading to oil film collapse. Grooves oriented transverse to sliding direction produce localised cavitation inside each pocket, which supports the theory that texture draws lubricant into the contact through the ‘inlet suction’ mechanism. These findings can aid texture design by showing how pockets can be used in practice to simultaneously control oil consumption, and reduce friction and wear along the stroke. It should be noted that the lubricant transport mechanisms described above should also result from other types of depressions, such those produced by porous coatings (provided they are smaller than the contact area). |
Databáze: | OpenAIRE |
Externí odkaz: |