Thermal, structural and morphological properties of High Density Polyethylene matrix composites reinforced with submicron agro silica particles and Titania particles
Autor: | B.O. Adewuyi, O.O. Daramola, Rotimi Sadiku, Isiaka Oluwole Oladele, Stephen C. Agwuncha |
---|---|
Jazyk: | angličtina |
Předmět: |
High Density Polyethylene
Thermogravimetric analysis Materials science Scanning electron microscope Rice husk ash 02 engineering and technology 010402 general chemistry 021001 nanoscience & nanotechnology 01 natural sciences 0104 chemical sciences Submicron agro waste silica particles Phase (matter) Orthorhombic crystal system Lamellar structure High-density polyethylene Composite material lcsh:Science (General) 0210 nano-technology Dispersion (chemistry) Mass fraction lcsh:Q1-390 |
Zdroj: | Journal of Taibah University for Science, Vol 11, Iss 4, Pp 645-653 (2017) |
ISSN: | 1658-3655 |
DOI: | 10.1016/j.jtusci.2016.08.006 |
Popis: | HDPE—based composites samples filled with 2, 4, 6, 8 and 10 wt.% submicron agro-waste silica particles extracted from rice husk ash (RHA) at constant 0.3 wt.% Titania loading were prepared using rapra single screw extruder at temperature of 200–230 °C. The extrudates were compressed with a laboratory carver press at a temperature of 230 °C for 10 min under applied pressure of 0.2 kPa and water cooled at 20 °C min −1 . Thermal, structural and morphological properties of the composites were studied. The results of the thermogravimetric analysis (TGA) revealed that the composites with 10 wt.% SiO 2 have the best maximum thermal degradation temperature of 438.73 °C. The crystal structure of neat HDPE, and the siliceous composites developed revealed two obvious diffractive peaks of about 21.3° and 23.7° corresponding to typical crystal plane (1 1 0) and (2 0 0) of orthorhombic phase respectively. The diffractive peaks do not shift with the addition of silica particles; this clearly indicates that the addition of silica particles did not exert much effect on the crystalline structure of HDPE. There is no much difference in the interplanar distance (d-value). Lamellar thickness (L) of HDPE increases with the addition of silica particles, which implies that silica particles aid the formation of more perfect crystals. Scanning electron microscopy studies indicated that there were chains inter diffusion and entanglement between HDPE matrix and the silica particles at lower weight fraction (2–4 wt.%) of submicron silica particles which resulted into homogeneous dispersion of the particles within the matrix. |
Databáze: | OpenAIRE |
Externí odkaz: | |
Nepřihlášeným uživatelům se plný text nezobrazuje | K zobrazení výsledku je třeba se přihlásit. |