How do the oxygenated functional groups in ether, carbonate and alcohol affect soot formation in Jet A2 diffusion flames?
| Autor: | Yong Ren Tan, Markus Kraft, Jethro Akroyd, Maurin Salamanca |
|---|---|
| Přispěvatelé: | Tan, YR [0000-0002-8029-9027], Salamanca, M [0000-0001-6584-9097], Akroyd, J [0000-0002-2143-8656], Apollo - University of Cambridge Repository, School of Chemical and Biomedical Engineering, The Cambridge Centre for Advanced Research and Education in Singapore |
| Rok vydání: | 2022 |
| Předmět: |
Smoke Point
Materials science Jet fuel General Chemical Engineering Analytical chemistry General Physics and Astronomy Energy Engineering and Power Technology medicine.disease_cause Mole fraction chemistry.chemical_compound Soot medicine Dimethyl ether Oxygenate Sooting tendency Chemical engineering [Engineering] Sooting Tendency General Chemistry Oxygenated fuel Smoke point Fuel Technology chemistry Volume fraction Dimethoxymethane Particle size PODE |
| Popis: | Four oxygenated fuels: ethanol (EtOH), dimethyl carbonate (DMC), dimethoxymethane (DMM) and polyoxymethylene dimethyl ether (PODE3) were blended with Jet A2 to investigate the sooting behaviour of the fuel mixtures. The smoke point was measured using wick-fed laminar diffusion flames as per the ASTM D1322 standard. The oxygen extended sooting index (OESI) was calculated to determine the sooting tendency of each mixture. Colour-ratio pyrometry and differential mobility spectrometry were used to measure the soot volume fraction (fv) and particle size distribution (PSD). The addition of oxygenated fuels caused a strong reduction in sooting tendency (i.e. OESI) at low blend strengths (5%) and a weaker linear reduction at higher blend strengths (10% and 20%). Each mixture showed a similar reduction at a given mole fraction of oxygenated fuel. The OESI broadly correlated with the soot volume fraction and particle size measurements. Increasing blend strengths resulted in smaller particles at the tip of the flame. The average particle size at the tip was influenced by the oxygen content but not the molecular structure of the oxygenated fuels, whereas the soot volume fraction in the wings was influenced by both the molecular structure of the oxygenated fuels and the oxygen/carbon ratio of the mixture. For the first time, fv and PSD have been reported for flames produced using Jet A2 blends in an ASTM D1322 lamp. The ability to relate data gathered using the ASTM D1322 standard for the sooting behaviour of different mixtures is going to be increasingly important as the aviation industry seeks to switch to sustainable fuels. National Research Foundation (NRF) This research was supported by the National Research Foundation, Prime Ministers Office, Singapore under its Campus for Research Excellence and Technological Enterprise (CREATE) programme. Y. R. Tan acknowledges financial support provided by Fitzwilliam College Cambridge, Trinity College Cambridge and the Cambridge Trust. M. Kraft gratefully acknowledges the support of the Alexander von Humboldt Foundation. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|