Comparison of the Evaporation and Condensation Heat Transfer Coefficients on the External Surface of Tubes in the Annulus of a Tube-in-Tube Heat Exchanger
| Autor: | Rick Smith, Weiyu Tang, David J. Kukulka, Wei Li |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2020 |
| Předmět: |
Mass flux
Control and Optimization Materials science 020209 energy Energy Engineering and Power Technology 02 engineering and technology Heat transfer coefficient lcsh:Technology evaporation heat transfer coefficient Boiling Heat exchanger 0202 electrical engineering electronic engineering information engineering Annulus (firestop) Electrical and Electronic Engineering Composite material Engineering (miscellaneous) Renewable Energy Sustainability and the Environment Turbulence lcsh:T 021001 nanoscience & nanotechnology Boiling point condensation Heat transfer 0210 nano-technology surface-enhanced tube Energy (miscellaneous) |
| Zdroj: | Energies, Vol 13, Iss 4, p 952 (2020) Energies Volume 13 Issue 4 |
| ISSN: | 1996-1073 |
| Popis: | An experimental study was carried out to explore the heat transfer characteristics on the outside of smooth and enhanced tubes, during evaporation and condensation of R134A in the annulus of a tube-in-tube heat exchanger. The three-dimensional enhanced surface tube consisted of primary enhancement patterns and secondary patterns results were compared to the performance of an equivalent smooth tube. The equivalent external diameter of the inside horizontal copper tubes used in this study was 19.05 mm, while the outer tube varied in size, allowing a comparison of heat transfer for different annulus dimensions. Tests were conducted with a fixed inlet/outlet vapor quality and a constant saturation temperature for varied mass velocities in the range of 30 to 100 kg/(m2∙s). For condensation, the ratio of heat transfer coefficient enhancement (enhanced tube/ smooth tube) was up to 1.78 this can be attributed to the turbulence increase, as well as liquid film re-distribution, produced from the dimples. Furthermore, the condensation heat transfer coefficient increased rapidly with increasing mass flux. For flow boiling in the annulus between the 1EHT tube and outer tube, the heat transfer coefficient during boiling was 11%&ndash 36% higher when compared to the smooth tube at xave = 0.35, while the performance of the 1EHT tube was not as good as the smooth tube at xave = 0.5. The heat transfer deterioration can be explained by decreased effective nucleate flow boiling heat transfer area and the flow pattern transition between a slug/wavy-stratified flow to wavy-stratified flow. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|