The effect of contouring on fatigue resistance of three types of fracture fixation plates
| Autor: | Felix Wipf, Mark E. Magill, Thomas J. Moore, Angela S.P. Lin, Chelsea M. Fechter, Robert E. Guldberg |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2016 |
| Předmět: |
030222 orthopedics
Contouring genetic structures Bone fractures 040301 veterinary sciences business.industry Dentistry 04 agricultural and veterinary sciences Bending 0403 veterinary science 03 medical and health sciences Fatigue resistance 0302 clinical medicine Fracture fixation Bone plate Fracture (geology) Medicine Bone plates Orthopedics and Sports Medicine Surgery business Brittle fracture Biomedical engineering Research Article |
| Zdroj: | Journal of Orthopaedic Surgery and Research |
| ISSN: | 1749-799X |
| Popis: | Background Metallic reconstruction plates used for fracture stabilization typically require intraoperative contouring for patient-specific anatomical fit. Despite this, characterization of plate mechanical properties after contouring has previously been limited. The objective of this study was to assess whether contouring affects fatigue resistance for three types of Stryker seven-hole stainless steel (SS) 316LVM fracture fixation plates. The hypothesis was that for each plate type, more contouring repetitions would result in lower fatigue resistance. Methods Plates were contoured using a bench-top plate bender to ±20° either 0×, 3×, 6×, or 9× (n = 5 per group) and tested in the straight configuration. Cyclic four-point bending was applied in an incremental stepwise staircase approach (one step = 100,000 cycles, 10 Hz) until failure (defined as brittle fracture or plastic deformation of 10° permanent bend). Moment-cycle product (MCP) was computed as the summation of maximum moment × number of cycles and used as the primary measure of fatigue resistance. Results No significant differences in fatigue resistance were detected between contouring groups for Basic Fragment Set (BFS) Reconstruction Plates. Significantly lower fatigue resistance was measured for 9× contoured Matta Pelvic System (MPS) Straight Plates compared to 0× contoured plates (p = 0.023). MPS Flex Plates contoured 3× had greater fatigue resistance than 0× contoured (p = 0.031) and 9× contoured plates (p = 0.032). Conclusions This work provides fatigue resistance-based evidence that clinicians should avoid high repetitions of contouring for MPS Straight Plates. Meanwhile, BFS Reconstruction Plates and MPS Flex Plates are not negatively affected by contouring. These results allow for improved intraoperative decisions about using or discarding plates after multiple contouring repetitions. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|