Influence of surface finishing and printing layer orientation on the surface roughness and flexural strength of stereolithography-manufactured dental zirconia

Autor: Y. Lu, L. Wang, A.M.O. Dal Piva, J.P.M. Tribst, I. Nedeljkovic, C.J. Kleverlaan, A.J. Feilzer
Přispěvatelé: Dental Material Sciences, Oral Regenerative Medicine (ORM)
Rok vydání: 2023
Předmět:
Zdroj: Lu, Y, Wang, L, Dal Piva, A M O, Tribst, J P M, Nedeljkovic, I, Kleverlaan, C J & Feilzer, A J 2023, ' Influence of surface finishing and printing layer orientation on surface roughness and flexural strength of stereolithography-manufactured dental zirconia ', Journal of the Mechanical Behavior of Biomedical Materials, vol. 143, 105944, pp. 1-18 . https://doi.org/10.1016/j.jmbbm.2023.105944
Journal of the Mechanical Behavior of Biomedical Materials, 143:105944, 1-18. Elsevier BV
ISSN: 1751-6161
DOI: 10.1016/j.jmbbm.2023.105944
Popis: Objective: To evaluate the effect of surface finishing and printing layer orientation on the surface roughness and flexural strength of three-dimensionally (3D) printed 3 mol% yttria-stabilized zirconia manufactured by stereolithography (SLA). Methods: Ninety bar-shaped zirconia specimens (1 mm x 1 mm x 12 mm) were 3D-printed via SLA. After debinding and sintering, they were randomly divided according to the printing layer orientation: parallel (PR) or perpendicular (PD) to the tensile surface for bending test. Each group was submitted to a surface finishing protocol (n=15/group): unpolished (subgroup 0), with polished tensile surface (subgroup 1), and with polished lateral and tensile surfaces (subgroup 3). Roughness of tensile surface was determined using a contact sensor and surface morphology was analyzed under Scanning Electron Microscopy (SEM). Flexural strength, apparent elastic modulus, and Weibull parameters were assessed using a 3-point bending test. Fractured specimens were examined to identify failure origins. Finite element analysis was used to evaluate tensile stress peaks and failure risk. Results: PR orientation exhibited higher strength, higher apparent elastic modulus, higher maximum principal stress peaks, and lower failure risk. For both layer orientations, groups with polished lateral and tensile sides (PR3 and PD3) were the strongest. SEM revealed that polishing led to changes in defect type, location, and size. Significance: SLA zirconia shows different mechanical properties according to surface roughness and defects. Orienting the printed layers parallel to the tensile side improves its mechanical performance. Polishing can significantly improve its flexural strength. It is necessary to reduce the final product's surface roughness and large pores for its best performance.
Databáze: OpenAIRE
Externí odkaz: