Prospects of Low-Pressure Cold Spray for Superhydrophobic Coatings
| Autor: | Anna Gibas, A. Baszczuk, Marcin Winnicki, Marek Jasiorski |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2019 |
| Předmět: |
Fabrication
Materials science thin SiO2 cold sprayed coatings Gas dynamic cold spray Surfaces and Interfaces Surface finish engineering.material Surfaces Coatings and Films Amorphous solid Contact angle Coating silica modification with FOTS multi-level roughness low-pressure cold spray hydrophobic coatings Materials Chemistry engineering Wetting Composite material Thermal analysis |
| Zdroj: | Coatings Volume 9 Issue 12 |
| ISSN: | 2079-6412 |
| DOI: | 10.3390/coatings9120829 |
| Popis: | A major challenge in materials engineering is the development of new materials and methods and/or novel combination of existing ones, all fostering innovation. For that reason, this study aims at the synergy between low-pressure cold spray (LPCS) as a tool for coating deposition and sol-gel technique for fabrication of the feedstock powder. The complementarity of both methods is important for the examined topic. On one side, the LPCS being automized and quick mean provides the solid-state of feedstock material in nondestructive conditions and hence the hydrophobicity imparted on the sol-gel route is preserved. On the other side, the sol-gel synthesis enables the production of oxide materials with enhanced deformability due to amorphous form which supports the anchoring while LPCS spraying. In the paper, several aspects including optimal fluoroalkylsilane (FOTS) concentration or substrate roughness are examined initially for altering the superhydrophobicity of produced coatings. Further, it is shown that the appropriate optimization of feedstock powder, being submicron silica matrices covered with two-layer FOTS sheath, may facilitate the anchoring process, support roughening the substrate or cause enhancement the coating hydrophobicity. All the discussion is supported by the characteristics including surface morphology, wettability and thermal behaviour examined by electron microscopy, water contact angle measurements and thermal analysis (TGA/DSC), respectively. The coatings presented in the paper are characterized by an uneven thickness of up to a few silica particles, but final hydrophobicity is provided uniformly on the surface by the formation of multi-level roughness by a detachment of outer layer from the SiO2 particles. Thus, the presented approach constitutes a simple and fast solution for the fabrication of functionalized coatings using LPCS including industrial potential and fundamental research character. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|