Production of phenols from lignin-derived slurry liquid using iron oxide catalyst
Autor: | Yuta Nakasaka, Teruoki Tago, Satoshi Shinohara, Takuya Yoshikawa, Taichi Yagi, Naonori Ryumon, Takao Masuda |
---|---|
Rok vydání: | 2014 |
Předmět: |
High pressure flow reactor
Depolymerization Process Chemistry and Technology Inorganic chemistry Ether Fluid catalytic cracking complex mixtures Iron oxide catalyst Catalysis chemistry.chemical_compound Hydrolysis chemistry Lignin conversion Phenols Environmental Science(all) Biomass utilization Slurry Lignin General Environmental Science |
Zdroj: | Applied Catalysis B: Environmental. 146:289-297 |
ISSN: | 0926-3373 |
DOI: | 10.1016/j.apcatb.2013.03.010 |
Popis: | A two-step process consisting of depolymerization and catalytic cracking without hydrogen addition was carried out to produce phenols from lignin. In the first step, lignin was depolymerized using a silica-alumina catalyst in a water/1-butanol solution at 623 K for 2 h. After the reaction, lignin-derived slurry liquid was obtained in 67 C-mol% yield. From the model studies, it was considered that lignin was mainly depolymerized via hydrolysis of aryl ether bonds between lignin units. For the second step, the catalytic reaction of the 1-butanol phase of the slurry liquid was carried out over an iron oxide catalyst using a high pressure fixed-bed flow reactor at 673 K. The catalytic reaction under high pressure steam conditions was effective for the suppression of the formation of solid products. In addition, the recovery fraction of phenols increased as the F H 2 O / F value (the flow rate ratio of steam to the slurry liquid) increased, resulting in 17% of phenols at F H 2 O / F = 5 for 2–4 h. From the model studies and our previous results, catechol and methoxyphenol in the slurry liquid were considered to be converted into phenols, cresols and other alkyl phenols over the iron oxide catalyst. |
Databáze: | OpenAIRE |
Externí odkaz: |