Influence of initial heating during final high temperature annealing on the offset of primary and secondary recrystallization in Cu-bearing grain oriented electrical steels
| Autor: | T. Van De Putte, P. Rodriguez-Calvillo, Sigrid Jacobs, Elke Leunis, O. Zacek, W. Saikaly |
|---|---|
| Rok vydání: | 2018 |
| Předmět: |
010302 applied physics
Materials science Annealing (metallurgy) Metallurgy General Physics and Astronomy Recrystallization (metallurgy) 02 engineering and technology Coercivity engineering.material Abnormal grain growth 021001 nanoscience & nanotechnology Microstructure 01 natural sciences lcsh:QC1-999 Grain size Grain growth 0103 physical sciences engineering 0210 nano-technology lcsh:Physics Electrical steel |
| Zdroj: | AIP Advances, Vol 8, Iss 4, Pp 047605-047605-7 (2018) |
| ISSN: | 2158-3226 |
| DOI: | 10.1063/1.4993681 |
| Popis: | The industrial production route of Grain Oriented Electrical Steels (GOES) is complex and fine-tuned for each grade. Its metallurgical process requires in all cases the abnormal grain growth (AGG) of the Goss orientation during the final high temperature annealing (HTA). The exact mechanism of AGG is not yet fully understood, but is controlled by the different inhibition systems, namely MnS, AlN and CuxS, their size and distribution, and the initial primary recrystallized grain size. Therefore, among other parameters, the initial heating stage during the HTA is crucial for the proper development of primary and secondary recrystallized microstructures. Cold rolled 0.3 mm Cu-bearing Grain Oriented Electrical Steel has been submitted to interrupted annealing experiments in a lab tubular furnace. Two different annealing cycles were applied:• Constant heating at 30°C/h up to 1000°C. Two step cycle with initial heating at 100°C/h up to 600°C, followed by 18 h soaking at 600°C and then heating at 30°C/h up to 1050°C. The materials are analyzed in terms of their magnetic properties, grain size, texture and precipitates. The characteristic magnetic properties are analyzed for the different extraction temperatures and Cycles. As the annealing was progressing, the coercivity values (Hc 1.7T [A/m]) decreased, showing two abrupt drops, which can be associated to the on-set of primary and secondary recrystallization. The primary recrystallized grain sizes and recrystallized fractions are fitted to a model using a non-isothermal approach. This analysis shows that, although the resulting grain sizes were similar, the kinetics for the two step annealing were faster due to the lower recovery. The on-set of secondary recrystallization was also shifted to higher temperatures in the case of the continuous heating cycle, which might end in different final grain sizes and final magnetic properties. In both samples, nearly all the observed precipitates are Al-Si-Mn nitrides, ranging from pure AlN to Si4Mn-nitride. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|