Effects of nanoparticle additives to diesel on the combustion performance and emissions of a flame tube boiler
| Autor: | Bilal Sungur, Hakan Ozcan, Bahattin Topaloglu |
|---|---|
| Přispěvatelé: | Ondokuz Mayıs Üniversitesi |
| Rok vydání: | 2016 |
| Předmět: |
Thermal efficiency
Boiler Materials science 020209 energy Nanoparticle 02 engineering and technology Combustion Industrial and Manufacturing Engineering Diesel fuel 020401 chemical engineering 0202 electrical engineering electronic engineering information engineering Exhaust emissions 0204 chemical engineering Electrical and Electronic Engineering Titanium oxide nanoparticles NOx Civil and Structural Engineering Aluminum oxide nanoparticles Waste management Mechanical Engineering Boiler (power generation) Building and Construction Pollution Titanium oxide General Energy Chemical engineering Temperature distributions Combustion chamber |
| Zdroj: | Energy. 113:44-51 |
| ISSN: | 0360-5442 |
| DOI: | 10.1016/j.energy.2016.07.040 |
| Popis: | Hakan, OZCAN/0000-0002-7848-3650; Sungur, Bilal/0000-0002-7320-1490 WOS: 000386410500005 This paper presents an experimental study about the effects of nanoparticles added to diesel fuels on the combustion performance and emissions of a flame tube boiler. Nanodiesel fuels were prepared by adding aluminum oxide (Al2O3) and titanium oxide (TiO2) nanoparticles. The performance and emissions measurements were realized in a residential, water-cooled, reversal flame tube boiler. The temperature distributions in the combustion chamber, combustion performance and exhaust gas emissions of nanodiesel with 100, 200 and 300 ppm nanoparticles were studied and these were compared with the neat diesel fuel. The results showed that addition of nanoparticles decreased the size of the peak temperature zones and increased the thermal efficiency slightly from about 90.4% to 90.9% with addition of nanoparticles up to 300 ppm. CO emissions decreased up to 200 ppm from 275 to 75 ppm by using 300 ppm Al2O3 nanoparticles, and decreased up to 50 ppm from 275 to 225 ppm by using 300 ppm TiO2 nanoparticles. It was observed that nanodiesels did not affect the NOx, emissions significantly, which were about 47-51 ppm. The results of Al2O3 and TiO2 nanoadditives showed similar trends, but Al2O3 nanodiesel has a bit better performance and emission characteristics compared to TiO2 nanodiesel. (C) 2016 Elsevier Ltd. All rights reserved. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect