Cutting efficiency of two heat-treated files in rotation and reciprocation motions
| Autor: | Hala Fayek Khalil, Mohamed Mokhtar Nagy, Engy M. Kataia, Mohamed M. Kataia |
|---|---|
| Rok vydání: | 2021 |
| Předmět: |
Rotation
business.industry Science Group ii 030206 dentistry Kinematics Structural engineering Curvature Cutting efficiency Heat treatment Cross section (geometry) 03 medical and health sciences 0302 clinical medicine 030220 oncology & carcinogenesis Heat treated General Earth and Planetary Sciences Reciprocation business Rotation (mathematics) General Environmental Science Mathematics |
| Zdroj: | Bulletin of the National Research Centre, Vol 45, Iss 1, Pp 1-5 (2021) |
| ISSN: | 2522-8307 |
| DOI: | 10.1186/s42269-021-00579-x |
| Popis: | Background This study aimed at assessing the effect of different kinematics as well as different instrument designs on efficiency of cutting of two heat-treated nickel–titanium systems. Forty resin canals with 30°-angle of curvature and a length of 16 mm were utilized in this research. They were divided into four groups depending on the instrument and the operating kinematic, group I; Azure rotary system in rotation motion, group II; Azure rotary system in Reciprocation motion, group III; Fanta AF One rotary system in rotation motion and group IV; Fanta AF One rotary system in reciprocation motion. Blocks were labeled and then weighed pre- and post-preparation with delta weight (Δ wt = wt pre − wt post) and data were documented for statistics evaluation. Results Resin canals prepared using Fanta AF One rotary system showed significantly higher weight loss than Azure rotary system in both rotation and reciprocation (P Conclusion The instrument’s cross section revealed a more significant impact on cutting efficiency than the motion used. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full text from SpringerLink