Investigation of Possible Mechanisms for Developing Long Steel Products with Ultrafine Grained Microstructure
| Autor: | Claudio Guarnaschelli, Tommaso Coppola, Ilaria Salvatori |
|---|---|
| Rok vydání: | 2014 |
| Předmět: |
Austenite
Toughness Materials science business.product_category Mechanical Engineering Metallurgy Alloy steel Recrystallization (metallurgy) engineering.material Microstructure Condensed Matter Physics Fastener Mechanics of Materials Ferrite (iron) engineering Formability General Materials Science business |
| Zdroj: | Materials Science Forum. :744-749 |
| ISSN: | 1662-9752 |
| Popis: | The obtainment of ultrafine grain microstructures, by the application of process parameters which are potentially feasible under industrial conditions, is attractive to develop a new generation of low alloy steel (Ultrafine Grain Steel, UFG) characterized by high strength and toughness, good cold/warm formability, environmentally-friendly process. The ferrite grain size refinement beyond existing levels by means of hot rolling mills, without requiring drastic plant changes, can be achieved by lowering the rolling temperature down to the range Ae3 - Ar3 in the finishing stands. In this temperature range different metallurgical mechanisms may take place. Austenite recrystallization is slower and there is a greater chance of obtaining non-recrystallized deformed austenite (pancake), which after phase transformation will give finer ferrite (Heavy Gamma Deformation). Or, in alternative, Deformation Induced Ferrite Transformation can occur especially in C-Mn steels, promoting the formation of ultrafine ferrite grains (DIFT). Most of the existing studies on UFG steel focus on flat products. In this paper the mechanisms to be exploited for producing UFG long products are identified and examined on different low and medium carbon non-alloyed steels, as the common grades used for fastener applications. In particular, Heavy Gamma Deformation and DIFT are investigated through laboratory tests aimed at determining the process parameters affecting the two mechanisms in different ranges of chemical composition. On the basis of the results found, some basic concepts for industrialization on modern hot rolling mills will be given. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|