Required length of guardrails before hazards

Autor: Heinz Hoschopf, Bernd Strnad, Wolfgang Sinz, Ernst Tomasch, Mark Gobald, Florian Schneider, Birgit Nadler, Herman Steffan, Friedrich Nadler
Rok vydání: 2011
Předmět:
Zdroj: Accident Analysis & Prevention. 43:2112-2120
ISSN: 0001-4575
DOI: 10.1016/j.aap.2011.05.034
Popis: One way to protect against impacts during run-off-road accidents with infrastructure is the use of guardrails. However, real-world accidents indicate that vehicles can leave the road and end up behind the guardrail. These vehicles have no possibility of returning to the lane. Vehicles often end up behind the guardrail because the length of the guardrails installed before hazards is too short; this can lead to a collision with a shielded hazard. To identify the basic speed for determining the necessary length of guardrails, we analyzed the speed at which vehicles leave the roadway from the ZEDATU (Zentrale Datenbank Tödlicher Unfälle) real-world accidents database. The required length of guardrail was considered the length that reduces vehicle speed at a maximum theoretically possible deceleration of 0.3g behind the barrier based on real-world road departure speed. To determine the desired length of a guardrail ahead of a hazard, we developed a relationship between guardrail length and the speed at which vehicles depart the roadway. If the initial elements are flared away from the carriageway, the required length will be reduced by up to an additional 30% The ZEDATU database analysis showed that extending the current length of guardrails to the evaluated required length would reduce the number of fatalities among occupants of vehicles striking bridge abutments by approximately eight percent.
Databáze: OpenAIRE