Remanufacturing and surface modification in micro-areas by laser beam and microTIG methods
| Autor: | J. Jakubowski, Przemysław Połaski |
|---|---|
| Jazyk: | angličtina |
| Rok vydání: | 2020 |
| Předmět: |
Cladding (metalworking)
0209 industrial biotechnology Materials science Gas tungsten arc welding 010102 general mathematics Mechanical engineering micro-areas microTIG method 02 engineering and technology Welding 01 natural sciences law.invention Laser technology 020901 industrial engineering & automation Machining law laser cladding lcsh:Technology (General) Surface modification lcsh:T1-995 0101 mathematics Remanufacturing Laser beams |
| Zdroj: | Przegląd Spawalnictwa, Vol 92, Iss 1 (2020) |
| ISSN: | 2449-7959 0033-2364 |
| Popis: | Over the past years, intensive development of welding technologies that enable precise impact on the workpiece has been observed. The laser technology is the most known and commonly used tool for precise machining, both in terms of obtaining the appropriate geometry and heat distribution. This technology is now easily available, but it still has many limitations in its "basic edition". An attractive alternative in machining micro-areas can be the arc method ‒ microTIG, which is a modification of the TIG method.The work compares the effects of cladding of selected pairs of substrate materials using the microTIG method and a laser beam. The results of microscopic tests and hardness measurements of deposits made with a laser beam and the microTIG method are presented. The advantage of cladding with the microTIG method was the possibility of obtaining deposits with a lower dilution of the substrate material in the clad weld compared to laser cladding. On the other hand, clad welds produced with the laser beam had a significantly smaller amount of welding defects. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|