| Popis: |
The study aimed to check the possibility of using computed tomography to observe fractures in coal samples before and after a triaxial compression test (TRX). The paper presents an innovative use of two specialized laboratory techniques: computed tomography and geomechanical triaxial compression test. Geomechanical tests were performed on a TRX-070, GCTS (USA) measuring triaxial system. A full stress-strain characteristic was recorded. Also, during the triaxial compression tests, the P and S wave velocities were measured and dynamic elastic moduli were determined. The results were compared. The sample was analyzed in two stages: CT measurement performed on raw coal sample (stage 1) and after the TRX test which destroyed the sample structure (stage 2). First, the sample was scanned reflecting the initial pores and microcracks system. The final stage represents the sample after the geomechanical test. A detailed pore structure analysis was performed for each of the stages. As a result of the proposed above-mentioned method, images of the pore structure were obtained after each step. The sample was analyzed for crack propagation and changes in the pore structure. The qualitative and quantitative interpretation was based on the determination of the number of voids, crack diameters, collapse angles, and comparison of the pore structure between the initial state of the sample and after the triaxial test. In the first stage (before the test), the largest object (identified as a microcrack) had a volume of approximately 16 mm3, after the sample was stress-tested (after the sample was destroyed), the largest identified object was about 15 times larger (240 mm3). It appeared that the coal sample was prone to fracturing in defined directions. Comprehensive research has demonstrated the legitimacy of using the proposed methodology to evaluate changes in the sample structure during the triaxial test. |
