Improved aging performance of vapor phase deposited hydrophobic self-assembled monolayers
| Autor: | Orla Slattery, Tony O’Hara, Syed A. M. Tofail, Cian O'Murchu, Frank H. Peters, Arun Kumar Gnanappa, Balazs Aszalos-Kiss |
|---|---|
| Rok vydání: | 2011 |
| Předmět: |
Materials science
Silicon Annealing (metallurgy) fungi Analytical chemistry General Physics and Astronomy chemistry.chemical_element Self-assembled monolayer Surfaces and Interfaces General Chemistry Condensed Matter Physics Silane Surfaces Coatings and Films Contact angle chemistry.chemical_compound chemistry X-ray photoelectron spectroscopy Monolayer Thin film |
| Zdroj: | Applied Surface Science. 257:4331-4338 |
| ISSN: | 0169-4332 |
| DOI: | 10.1016/j.apsusc.2010.12.052 |
| Popis: | A hydrophobic self-assembled monolayer (SAM) of fluoro-octyl-trichloro-silane (FOTS) was deposited on silicon using a vapor phase technique. The aging of the hydrophobic layer was examined using water contact angle measurements. It has been found that while such monolayer films suffer from a loss of hydrophobicity with time, pre-immersion nitrogen annealing can significantly improve the aging characteristics of these monolayers. The effect of nitrogen annealing on the improved aging properties of SAM coatings has been investigated by atomic force microscopy (AFM) and X-ray photoelectron spectroscopy (XPS). The hydrolytic stability and the effect of nitrogen annealing were studied by morphological evolution during immersion. A spontaneous formation of silane mounds on the surface of the monolayers was found by AFM. These mounds have been irreversibly transformed from initially uniform hydrophobic surface layers. It is highly probable that the compliance of these mounds can reasonably allow hydrophilic sites to be located around the mounds. Interestingly, the density of these mounds formation is very less on the annealed samples. XPS reveals a higher level of coverage by the N2-annealed film due to agglomeration. A relative abundance of CF3 and CF2 moieties in the annealed film may explain the enhancement of the hydrophobicity as revealed by higher level of water contact angle. This hydrophobicity was found to be significantly stable in water. This novel finding explains the improved hydrophobic stability of FOTS monolayers as primarily a morpho-chemical effect that originates from the densification of the monolayers upon annealing. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect