A novel wireless, passive CO2sensor incorporating a surface acoustic wave reflective delay line
| Autor: | Wen Wang, Ikmo Park, Keekeun Lee, Taehyun Kim, Sangsik Yang |
|---|---|
| Rok vydání: | 2007 |
| Předmět: |
Materials science
business.industry Attenuation Surface acoustic wave Phase (waves) Grating Condensed Matter Physics Network analyzer (electrical) Atomic and Molecular Physics and Optics Optics Transducer Mechanics of Materials Signal Processing Reflection (physics) General Materials Science Time domain Electrical and Electronic Engineering business Civil and Structural Engineering |
| Zdroj: | Smart Materials and Structures. 16:1382-1389 |
| ISSN: | 1361-665X 0964-1726 |
| DOI: | 10.1088/0964-1726/16/4/053 |
| Popis: | A 440 MHz wireless and passive surface acoustic wave (SAW) chemical sensor was developed for CO2 detection. The developed SAW gas sensor is composed of single phase unidirectional transducers (SPUDTs), three shorted grating reflectors, and CO2-sensitive polymer film on 41° YX LiNbO3 substrate. Coupling of modes (COM) modeling was used to find optimal design parameters. Using the extracted design parameters, the SAW device was fabricated. Teflon AF 2400 was used as the sensitive film because it provides high CO2 solubility, permeability and selectivity. In wireless device testing using a network analyzer, four sharp reflection peaks with high signal-to-noise (S/N) ratio, small signal attenuation, and few spurious peaks were observed in the time domain. The time positions of the reflection peaks were well matched with the predicted values from the simulation. Infusion of CO2 into the chamber induced large phase shifts of the reflection peaks. Good linearity and repeatability were observed for a CO2 concentration of 0–450 ppm. The obtained sensitivity was 1.98° ppm−1. Temperature and humidity effects were also investigated during the sensitivity evaluation process. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|