Reverse core-annular flow of Geldart Group B particles in risers

Autor: Jia Wei Chew, Ray Cocco, S.B. Reddy Karri, Ted M. Knowlton, Roy Hays, Christine M. Hrenya, John G. Findlay
Rok vydání: 2012
Předmět:
Zdroj: Powder Technology. 221:1-12
ISSN: 0032-5910
DOI: 10.1016/j.powtec.2011.12.019
Popis: Experiments involving monodisperse Geldart Group B particles have been carried out in a pilot-scale riser of a circulating fluidized bed (CFB). Several combinations of superficial gas velocity (Us), solid flux (Gs), average particle diameter (dave), and particle material density (ρs) were investigated. Surprisingly, the experiments reveal the presence of a reverse core-annulus profile (i.e., a dense core with a dilute annulus) under certain conditions. Specifically, for the large glass beads (dave = 650 μm, ρs = 2500 kg/m3), the reverse core-annulus profile was observed near the top of the riser for all Us and Gs combinations examined. For high-density polyethylene (HDPE) pellets (dave = 650 μm, ρs = 900 kg/m3) of the same dave, reverse core-annulus was observed at the top of the riser only at relatively low Gs. However, for the smaller glass beads (dave = 170 μm, ρs = 2500 kg/m3), the traditional core-annulus profile was observed for all Us and Gs combinations. Although previous work provides possible explanations for this behavior (gas-phase turbulence, etc.), the evidence obtained in this system suggests a novel dominant factor for reverse core-annulus flow: the particle Stokes number (St). Lower-St particles are more apt to follow the gas exiting the riser, while higher-St particles have a longer relaxation time and thus are more likely to re-enter the riser after collision with the roughened rounded-elbow exit. Accordingly, the re-direction of particles from the rounded-elbow exit and back into riser due to large-scale roughness along the elbow is greater for higher-St particles.
Databáze: OpenAIRE