The effects of morphometric elements of the channel on hydraulic resistance of machine channels of pumping stations
| Autor: | Oybek Vokhidov, Dilshod Bazarov, Bakhtiyar Uralov, Bakhtiyar Matyakubov, Makhfuz Akhmadi, Farokhiddin Uljaev |
|---|---|
| Rok vydání: | 2020 |
| Předmět: | |
| Zdroj: | IOP Conference Series: Materials Science and Engineering. 869:072015 |
| ISSN: | 1757-899X 1757-8981 |
| DOI: | 10.1088/1757-899x/869/7/072015 |
| Popis: | Presents the results of hydraulic studies in pressureless and pressure water conduits, the results of which showed that the dependences obtained for calculating the hydraulic resistance in round pressure pipes cannot be distributed without the corresponding adjustments of pressureless channels (provided that the diameter of the pipe is replaced in the corresponding calculations with a value where hydraulic radius). In particular, it follows (and this is confirmed by the data of the corresponding experimental studies published in the literature) that in the case of pressureless channels, the pressure loss coefficient, and therefore the pressure loss, depends not only on the relative roughness and Reynolds number, but also on the shape of the cross section the channel. Moreover, if for hydraulically smooth pressureless channels this dependence can be considered to a first approximation clarified, then for channels whose wetted surface is characterized by the presence of a certain roughness, the question of its influence, as well as the shape of the channel cross section on the pressure loss, is far from roughly approximate solution. The paper also considers the general equation of fluid motion in pressureless channels and the functional dependences of the coefficient of hydraulic friction on the Reynolds number, relative roughness, and on the shape of the living section of the channel; resistance formulas are first for the simplest with respect to the cross-sectional shape of the channels (round and infinitely wide rectangular), and then for channels with a more complex cross-sectional shape. To take into account the effect (on the pressure loss) of the channel cross-sectional shape and the presence of a flow with a free surface in it, additional correction factors are introduced (using the hydraulic radius concept) as well as new dependencies and formulas for determining the hydraulic friction coefficient are given, s taking into account the influence of morphometric elements of the channel on the hydraulic resistance of the machine channels of pumping stations. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|