Microcalorimetry for characterization of film formation and cure of coatings and adhesives
| Autor: | S.A. Adamovsky, Dirk Lellinger, Ingo Alig, Harald Oehler, Christoph Schick |
|---|---|
| Rok vydání: | 2008 |
| Předmět: |
chemistry.chemical_classification
Isothermal microcalorimetry Materials science General Chemical Engineering Organic Chemistry Analytical chemistry Polymer Heat capacity Isothermal process Surfaces Coatings and Films chemistry Thermocouple Thermoelectric effect Materials Chemistry Adhesive Composite material Curing (chemistry) |
| Zdroj: | Progress in Organic Coatings. 61:166-175 |
| ISSN: | 0300-9440 |
| DOI: | 10.1016/j.porgcoat.2007.09.043 |
| Popis: | A new microcalorimeter with eight parallel channels using robust, low cost sensors for characterization of coatings and adhesives is described and first experiments on coatings and adhesives are presented. The calorimetric sensors are based on thin glass plates (20 mm × 20 mm, thickness 150 μm) with heater and thermocouple sputtered on the surfaces (calorimetric active area of about 9 mm2). The setup allows heating and cooling experiments as well as isothermal measurements in the temperature-modulated mode with up to eight sensors in parallel. The measured quantities are the real (C′p) and imaginary part (C″p) of the complex heat capacity (Cp*=C′p−iC″p), the related absolute value of the heat capacity (|Cp*|) and the heat flow ϕ. An industrial computer (NI PXI system) with specific software for calibration and data recording controls the electronic components. Sensors can be embedded in a temperature controlled oven (heating and cooling by Peltier elements) or alternatively in a climatic cabinet with controlled temperature and humidity. The method has been applied successfully to monitoring of film formation of aqueous polymer dispersions (styrene-acrylate copolymer) and curing of coatings. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect