Surface modification of austenitic stainless steel on the surface of electric contact during low frequency current circulation
| Autor: | J. Ferron, B.J. Gómez, L. Nachez, Jorge Feugeas |
|---|---|
| Rok vydání: | 2006 |
| Předmět: |
Materials science
Metallurgy Metals and Alloys Surfaces and Interfaces engineering.material Plasma-immersion ion implantation Electrical contacts Surfaces Coatings and Films Electronic Optical and Magnetic Materials Ion implantation Physical vapor deposition Materials Chemistry engineering Surface modification Surface layer Austenitic stainless steel Nitriding |
| Zdroj: | Thin Solid Films. 513:206-211 |
| ISSN: | 0040-6090 |
| DOI: | 10.1016/j.tsf.2006.02.012 |
| Popis: | During process of surface treatment of steels using plasmas (ion nitriding, physical vapor deposition and chemical vapor deposition, plasma immersion ion implantation, etc.), normally, one of the surfaces of the pieces has to be in electrical contact with one of the electrodes. In this work, we investigate the surface modification of the SAE EV12 stainless steel after being in electrical contact with the cathode during a normal process of ion nitriding. The physical conditions used were of a square wave electrical current of 10, 100 and 1000 Hz with an amplitude between 40 A m −2 and 80 A m −2 passing during 40 min. The treated surface was studied under Auger emission spectroscopy and grazing angle X-ray diffraction. The results have shown that a surface layer of 60 nm is strongly altered, and that the results depend on the frequency of the applied voltage and the pressure of contact between the surface and the cathode. In this surface layer, we could see the Fe–Cr, MnO and a carbide of the type (Fe,Ni) 23 C 6 called haxonite, only reported in meteorites. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect