Autor: |
D.W. Greenwood, A.R. Susoeff, F R Marshall, R.S. Hawke, P R Bowen |
Rok vydání: |
1992 |
Předmět: |
|
DOI: |
10.2172/7047151 |
Popis: |
a series of tests was conducted to determine the operating requirements needed to obtain maximum projectile velocity within the engineering design limits of a two-stage light-gas gun with a 7.6 mm (0.30 inch) diameter bore launch tube. The tests were conducted in a medium vacuum flight range. Previous experience with the gun was used to establish the minimum requirements for optimum efficiency. Two operating parameters, propellant load and drive gas pressure, were varied in order to find an initial optimum operating condition at a conservative propellant load. Propellant load and driver gas pressure were then incrementally increased. This procedure was methodically applied until significant mechanical deformation of a critical gun component took place. This report presents the results of these tests. Projectile velocity was measured to better than 3 percent accuracy using a magnetic induction technique. A 0.485 gram polycarbonate projectile was launched to a velocity of 7.77 km/s during the tests. 13 refs. |
Databáze: |
OpenAIRE |
Externí odkaz: |
|