Point defects and pre-dose requirements for sensitization of the 300°C TL peak in natural quartz
Autor: | Milena Ribas de Miranda, Sandra de Brito Barreto, Helen J. Khoury, Pedro L. Guzzo, Armando Hideki Shinohara |
---|---|
Rok vydání: | 2008 |
Předmět: | |
Zdroj: | Physics and Chemistry of Minerals. 36:75-85 |
ISSN: | 1432-2021 0342-1791 |
DOI: | 10.1007/s00269-008-0259-x |
Popis: | This paper discusses the structural features required to stimulate a strong thermoluminescence (TL) glow peak near 300°C in clear natural quartz. For that reason, fresh TL data taken from several specimens prepared from five single crystals with known impurity content are shown. The TL emission was measured with a test dose of 10 mGy of γ-rays in the readout intervals 50–160 and 160–320°C. The readings were carried out prior and after the administration of a pre-dose of 175 kGy of γ-rays followed by heat-treatments at 400°C. For each single specimen, the OH content and the population of inclusions were evaluated by infrared spectroscopy and optical microscopy, respectively. The darkening induced by high γ dose was evaluated by optical spectroscopy. It was observed that the absorption at 475 nm and TL responses decrease with increase of the OH. It was shown that both smoky darkening and TL signals were better explained in terms of Li/Al and Li/OH content ratios rather than the absolute values of aluminum and alkali concentrations. The sensitization with high γ dose and heating is essential to create and stabilize a class of defects sites with Li+ ions dislodged from [AlO4/Li]0 and Li-dependent OH centers. It is suggested that the defect sites formed with Li+ act as electron traps during test dose irradiation, whereas electron-hole recombination occurs essentially at [AlO4]0 centers during the TL output near 300°C. |
Databáze: | OpenAIRE |
Externí odkaz: |