Mechanical behaviour of grouted sleeve splice under uniaxial tensile loading

Autor: Zhong Peng, Li Yubo, Liu Xuan, Shaobin Dai, Mingzhong Zhang, Lu Zhiwei, Jun Huang
Rok vydání: 2019
Předmět:
Zdroj: Engineering Structures. 186:421-435
ISSN: 0141-0296
DOI: 10.1016/j.engstruct.2019.02.033
Popis: This paper presents an experimental and analytical study on mechanical behaviour of two kinds of new low-cost grouted sleeves processed by seamless steel pipe, i.e., grouted sleeve with wedge and grouted sleeve with wedge and thread, under uniaxial tension. In total, twenty-two rebar splice specimens with various embedded lengths, spliced bar diameters and wedge lengths are prepared and tested. The test results indicate that the performance of both grouted splices meets the requirements of ACI318 and JGJ107. The required embedded length of rebar in the splice is found to be around 6–6.4 times the spliced bar diameter due to confinement effect. The tensile capacity of the splice increases with increasing diameter of the anchorage segment of the spliced bar, and length and slope of the wedge at both ends of the sleeve. Because of the good performance of wedges threads do not significantly improve the tensile capacity of the sleeve but improve the bond strength and bearing capacity in non-wedge segment of the sleeve. The tensile capacity of the specimen is slightly lower than that of steel bar and the reduction coefficient of bearing capacity is estimated. An analytical model is proposed to predict the tensile capacity of grouted sleeves considering the effects of confinement and reduction of tensile capacity of the splices, the predictions of which are in good agreement with experimental data.
Databáze: OpenAIRE
Externí odkaz: