Quality improvement of calibrated steelby surface deformation. Part 2. Effect of enveloping surface deformation on residual stresses in cylindrical bars
Autor: | S. A. Zaides, Van Anh Pham, L. G. Klimova |
---|---|
Rok vydání: | 2021 |
Předmět: |
Materials science
0211 other engineering and technologies Metals and Alloys 02 engineering and technology Deformation (meteorology) Residual Burnishing (metal) 020303 mechanical engineering & transports Compressive strength 0203 mechanical engineering Machining Residual stress Ultimate tensile strength Compression (geology) Composite material 021102 mining & metallurgy |
Zdroj: | Izvestiya. Ferrous Metallurgy. 64:330-336 |
ISSN: | 2410-2091 0368-0797 |
DOI: | 10.17073/0368-0797-2021-5-330-336 |
Popis: | Cold-drawn metal has a number of undeniable advantages over the hot-rolled one. Increased hardness, high surface quality, stability of the diametrical dimension along the length of the workpiece are the basis for choosing calibrated metal as effective workpieces for the manufacture of long parts such as shafts, axles, and rods. In some cases, such workpieces require a small amount of machining, for example, threading or making necks at the ends of a bar. The wider use of the calibrated metal is hindered by residual stresses that are formed during its manufacture. In the first part of this article, it was proposed to use small plastic deformations to control residual stresses. By the example of a new process of surface plastic deformation, which is called orbital burnishing, the working and residual stresses in cylindrical workpieces are determined. In the second part of the article, the process of enveloping surface plastic deformation is considered, which, at high productivity, makes it possible to reduce the residual tensile stresses in the calibrated metal or form the surface layers of the workpiece compressive stress. A technique for the experimental determination of residual stresses in the volume of a body is based on layer-by-layer removal of the inner and outer layers of cylindrical samples. Influence of the main parameters of the enveloping deformation process on the components of the residual stress tensor is established. A range of relative compressions (0.1 – 1.0 %) is revealed, at which residual compressive stresses are formed in the surface layers of the workpiece. It was found that at a relative compression of 0.5 %, the maximum residual compression stresses are created. Enveloping surface deformation has a positive effect on the residual stress state and on colddrawn metal – the residual tensile stresses can be reduced, removed or converted into compressive ones. |
Databáze: | OpenAIRE |
Externí odkaz: |