Microstructural characterization of CIGS formation using different selenization processes

Autor: Cherng-Yuh Su, Horng-Show Koo, Yu-Ting Ding, Kuang-Hsiang Liao
Rok vydání: 2013
Předmět:
Zdroj: Applied Surface Science. 270:139-144
ISSN: 0169-4332
DOI: 10.1016/j.apsusc.2012.12.142
Popis: Cu(In 1− x ,Ga x )Se 2 (CIGS) thin films were prepared by the sputtering of CuInGa precursors followed by chalcogenization via an isothermal (one-zone) selenization and a two-zone selenization. The effects of two selenization processes on the microstructural characteristics of CIGS films were also studied. In addition, we varied the selenization temperature for the two processes between 450 °C and 580 °C to investigate this effect on the microstructural characteristics and compositions of the CIGS films. The results indicated that the CIGS thin films formed using isothermal selenization had dense grain structure whose grains increased in size after an increase in the selenized temperature. However, the Se/(Cu + In + Ga) ratios of the films indicated that Se was distributed non-uniformly in the films, with Se-saturated CIGS present on the front side of the films and incompletely formed CIGS on the back side. In addition, it was noticed that Ga accumulated in large amounts in the films, depending on the chemical affinity between In and Se. Comparatively, the films prepared using two-zone selenization showed Ga accumulation that was only slightly greater than that in the films fabricated by the isothermal selenization. It is likely that the slow selenization of the CIG precursors reduced the extent of Ga accumulation because of the presence of Se in insufficient amounts. However, the presence of Se in insufficient amounts may also format the CIGS thin films with a porous microstructure.
Databáze: OpenAIRE
Externí odkaz: