Microstructure Evolution and Compressive Properties of Multilayered Al/Ni Energetic Structural Materials under Different Strain Rates
Autor: | Xiang Liu, Zhifu Mao, Mingzhi Wang, Zixuan Weng, Jingzhe Zhang, Hongyi Wang, Jie Tao, Jingli Li |
---|---|
Rok vydání: | 2020 |
Předmět: |
010302 applied physics
Materials science Structural material Mechanical Engineering 02 engineering and technology Split-Hopkinson pressure bar Strain hardening exponent Strain rate 021001 nanoscience & nanotechnology Microstructure Compression (physics) Hot pressing 01 natural sciences Compressive strength Mechanics of Materials 0103 physical sciences General Materials Science Composite material 0210 nano-technology |
Zdroj: | Journal of Materials Engineering and Performance. 29:506-514 |
ISSN: | 1544-1024 1059-9495 |
DOI: | 10.1007/s11665-020-04589-0 |
Popis: | Multilayered Al/Ni energetic structural materials integrating exothermic properties and mechanical properties were prepared by the method of electrodeposition and hot pressing in this research. Then, the uniaxial quasi-static compression and split Hopkinson pressure bar experiments were conducted at strain rates from 10−4 to 6.5 × 103 s−1 at room temperature. The effects of compression strain rate on the microstructure evolution and the compressive properties of multilayered Al/Ni energetic structural materials were systematically investigated. With increasing quasi-static compression strain rate, the compression strength increased slightly for two kinds of Al/Ni multilayers prepared under different hot pressing time. With the hot pressing process extending to 4 h, the dynamic compression strength of multilayered Al/Ni composites monotonically increased from 494.7 to 564.2 MPa with increasing strain rate. It was shown that Al/Ni energetic structural materials exhibited evident strain hardening and strain rate strengthening. However, when the compression strain rate reached 6500 s−1, the Al/Ni composite prepared with the hot pressing time of 1 h showed prominent thermal softening. Notwithstanding, it was found that the compression strength of Al/Ni composite prepared at 4 h was evidently higher than that at 1 h, since the second phase reinforcement counteracted the thermal softening. In addition, the critical failure strain presented obviously increasing tendency with the increased compression strain rates. |
Databáze: | OpenAIRE |
Externí odkaz: |