Characteristics and Heat Treatment of Cold-Sprayed Al-Sn Binary Alloy Coatings
| Autor: | H.J. Kim, X.J. Ning, D.J. Jung, C. Lee |
|---|---|
| Rok vydání: | 2008 |
| Zdroj: | International Thermal Spray Conference. |
| ISSN: | 2768-1505 2768-1491 |
| DOI: | 10.31399/asm.cp.itsc2008p1191 |
| Popis: | In this study, Al-Sn binary alloy coatings were prepared with Al-5wt.%Sn (Al-5Sn) and Al-10wt.%Sn (Al-10Sn) gas atomized powders by low pressure and high pressure cold spray process. The microstructure and microhardness of the coatings were characterized. The as-sprayed coating were heat treated at 150, 200, 250 and 300 °C for 1 hour, respectively. The effect of heat treatment on microstructure, microhardness and content of Sn phase of the coatings were investigated. The bonding strength of as-sprayed and heat treated Al-Sn coatings were also studied. The results show that the dense and well-bonded Al-10Sn coating can be deposited by low pressure with helium gas while Al-5Sn coating by high pressure cold spray with nitrogen gas. The content of Sn for both Al-5Sn and Al- 10Sn in as-sprayed coatings are consistent with that in feed stock powders. The coarsening and/or migration of Sn phase in both coatings were observed when the annealing temperature exceeds 200 °C. Furthermore, the microhardness of the coatings decreased significantly under the annealing temperature of 250 °C. EDAX analysis shows that the heat treatment has no significant effect on content of Sn phase in Al-5Sn coatings. Bonding strength of as-sprayed Al-10Sn coating is slightly higher than that of Al-5Sn coating. Annealing under 200 °C can increase the bonding strength of Al-5Sn coatings. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|