Correlation between motion of source bender element and feedback signal induced by self-monitoring
Autor: | Toshihiro Ogino |
---|---|
Rok vydání: | 2021 |
Předmět: |
Physics
Surface (mathematics) 021110 strategic defence & security studies Acoustics 0211 other engineering and technologies Motion (geometry) 02 engineering and technology Bending Geotechnical Engineering and Engineering Geology Signal Transfer function Displacement (vector) Correlation Element (category theory) 021101 geological & geomatics engineering Civil and Structural Engineering |
Zdroj: | Soils and Foundations. 61:175-184 |
ISSN: | 0038-0806 |
DOI: | 10.1016/j.sandf.2020.11.008 |
Popis: | Since the introduction of bender element tests to soil testing, the reliability of the estimated travel time has been the most serious problem. The author has previously shown a potential solution whereby removing the response of the bender element subsystem from the whole response could dramatically improve the accuracy of the travel time estimation. In order to lay the foundation for estimating the response of the bender element subsystem, this paper examines the correlation between the displacements of the element and the induced feedback signals by employing a self-monitoring element. The response of the self-monitoring element is modeled as a transfer function involving two internal transfer functions that relate the input signals to the displacements and the displacements to the feedback signals, respectively. Using a laser displacement sensor, the displacements are directly measured through the entire surface and reveal the three-dimensional bending motion of the element oscillating in both longitudinal and width directions. The feedback signals are similar to, but inconsistent with, the tip displacements, and an attempt is made to correct the feedback signals. Finally, a conclusion is given on the potential for estimating the response of the bender element subsystem using the self-monitoring element. |
Databáze: | OpenAIRE |
Externí odkaz: |