Differences and similarities between kraft and oxygen delignification of softwood fibers: effects on chemical and physical properties

Autor: Cláudia Vicente Esteves, Olena Sevastyanova, Elisabet Brännvall, Sören Östlund
Rok vydání: 2021
Předmět:
Zdroj: Cellulose. 28:3149-3167
ISSN: 1572-882X
0969-0239
DOI: 10.1007/s10570-021-03713-0
Popis: The fiber properties after oxygen delignification and kraft pulping were studied by looking into the chemical characteristics and morphology. The effect of the two processes on the fibers was evaluated and compared over a wider kappa number range (from 62 down to15). Wide-angle X-ray scattering, nuclear magnetic resonance and fiber saturation point were used to characterize the fiber network structure. Fiber morphology and fiber dislocations were evaluated by an optical image analysis. The total and surface fiber charges were studied by conductometric and polyelectrolyte titrations. The fiber wall supramolecular structure, such as crystallinity, size of fibril aggregates, pore size and pore volume, were similar for the two processes. The selectivity, in terms of carbohydrate yield, was equal for kraft cooking and oxygen delignification, but the selectivity in terms of viscosity loss per amount of delignification is poorer for oxygen delignification. Clearly more fiber deformations (2–6% units in curl index) in the fibers after oxygen delignification were seen. Introduction of curl depended on the physical state of the fibers, i.e. liberated or in wood matrix. In the pulping stage, the fiber continue to be supported by neighboring fibers, as the delignified chips maintain their form. However, in the subsequent oxygen stage the fibers enter in the form of pulp (liberated fibers), which makes them more susceptible to changes in fiber form. Graphic abstract
Databáze: OpenAIRE
Externí odkaz: