Deformation mechanism in Al0.1CoCrFeNi Σ3(111)[11̄0] high entropy alloys – molecular dynamics simulations
| Autor: | Cuixia Liu, Zhenhai Xia, Yu-Chia Yang |
|---|---|
| Rok vydání: | 2020 |
| Předmět: |
010302 applied physics
Materials science General Chemical Engineering High entropy alloys Modulus 02 engineering and technology General Chemistry Strain rate 021001 nanoscience & nanotechnology 01 natural sciences Deformation mechanism 0103 physical sciences Ultimate tensile strength Partial dislocations Grain boundary Deformation (engineering) Composite material 0210 nano-technology |
| Zdroj: | RSC Advances. 10:27688-27696 |
| ISSN: | 2046-2069 |
| DOI: | 10.1039/d0ra01885f |
| Popis: | High entropy alloys (HEAs), composed of multiple components with equal or near atomic proportions, have extraordinary mechanical properties and are expected to bear the impact of high-speed forces in armor protection structure materials. In order to understand the deformation behaviour of HEAs under tensile and compressive loading, molecular dynamics simulations were performed to reveal the deformation mechanism and mechanical properties of three crystal structures: Al0.1CoCrFeNi HEAs without grain boundaries (perfect HEAs), Al0.1CoCrFeNi HEAs with grain boundaries of Σ3(111)[10] (GBs HEAs) and grain boundaries of Σ3(111)[10] with chemical cluster HEAs (cluster-GBs HEAs). The mechanical properties of the three models at the same strain rate were discussed. Then, the mechanical properties at different strain rates were analyzed. The movement and direction of internal dislocations during the deformation process were investigated. The simulation results show that the GBs HEAs and the cluster-GBs both play an important role in the deformation and failure of the HEAs. Under tensile loading, three behaviour stages of deformation were observed. Cluster-GBs HEAs have a larger yield strength and Young's modulus than that of GBs and perfect HEAs. The higher the strain rate is, the greater the stress reduction rate. Under compressive loading, there are only two behaviour stages of deformation. Cluster-GBs HEAs also have the largest yield strength. Under tensile and compressive deformation, Shockley partial dislocations of 1/6 are dominant and their moving direction and effect on mechanical properties are discussed. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|