Investigation of the Influence of Fillers of Various Nature on the Properties of Polyether Sulfone and Determination of the Possibility of Using Composites on their Basis in 3D-Printing
| Autor: | Azamat A. Zhansitov, Azamat L. Slonov, S.Yu. Khashirova, Elina V. Khakyasheva, Ismel V. Musov, L. Kh. Kuchmenova |
|---|---|
| Rok vydání: | 2018 |
| Předmět: |
Materials science
business.industry Mechanical Engineering 3D printing 02 engineering and technology 021001 nanoscience & nanotechnology Condensed Matter Physics Talc Sulfone chemistry.chemical_compound 020401 chemical engineering chemistry Mechanics of Materials medicine General Materials Science 0204 chemical engineering Composite material 0210 nano-technology business medicine.drug |
| Zdroj: | Materials Science Forum. 935:11-14 |
| ISSN: | 1662-9752 |
| DOI: | 10.4028/www.scientific.net/msf.935.11 |
| Popis: | The results of the studies of the effect of excipients of mineral and organic origin on the mechanical properties of polyether sulfone based on 4,4'-dihydroxydiphenyl and 4,4'-dichlordiphenylsulfone are adduced. It has been shown that the introduction of hard fillers is accompanied by the increased modulus and reduced ductility of the polymer matrix, the intensity of these effects depends on the concentration, shape and particle size additives. It was revealed that the composites with talc and discrete carbon fibers were characterized by higher mechanical properties. Their test as materials for FDM 3D printing method shows the highest suitability composites with talc for this technology. |
| Databáze: | OpenAIRE |
| Externí odkaz: |
|