| Autor: |
A. Karimi Taheri, Mohammad Reza Aboutalebi, M. Morakabati, S.M. Abbasi, Sh. Kheirandish |
| Rok vydání: |
2011 |
| Předmět: |
|
| Zdroj: |
Intermetallics. 19:1399-1404 |
| ISSN: |
0966-9795 |
| DOI: |
10.1016/j.intermet.2011.05.005 |
| Popis: |
The deformation behavior of a 49.8 Ni-50.2 Ti (at pct) alloy was investigated using the hot compression test in the temperature range of 700 °C–1100 °C, and strain rate of 0.001 s−1 to 1 s−1. The hot tensile test of the alloy was also considered to assist explaining the related deformation mechanism within the same temperature range and the strain rate of 0.1 s−1. The processing map of the alloy was developed to evaluate the efficiency of hot deformation and to identify the instability regions of the flow. The peak efficiency of 24–28% was achieved at temperature range of 900 °C–1000 °C, and strain rates higher than 0.01 s−1 in the processing map. The hot ductility and the deformation efficiency of the alloy exhibit almost similar variation with temperature, showing maximum at temperature range of 900 °C–1000 °C and minimum at 700 °C and 1100 °C. Besides, the minimum hot ductility lies in the instability regions of the processing map. The peak efficiency of 28% and microstructural analysis suggests that dynamic recovery (DRV) can occur during hot working of the alloy. At strain rates higher than 0.1 s−1, the peak efficiency domain shifts from the temperature range of 850 °C–1000 °C to lower temperature range of 800 °C–950 °C which is desirable for hot working of the NiTi alloy. The regions of flow instability have been observed at high Z values and at low temperature of 700 °C and low strain rate of 0.001 s−1. Further instability region has been found at temperature of 1000 °C and strain rates higher than 1 s−1 and at temperature of 1100 °C and all range of strain rates. |
| Databáze: |
OpenAIRE |
| Externí odkaz: |
|
Full Text from ScienceDirect