| Popis: |
Since the introduction of a grooved cylinder, the single screw extruder’s feed section is a multifunctional zone. Currently, the mathematical approaches for the prediction of the pressure development and the output-performance are not sufficient. Most existing models consider the synthetic granules as a homogeneous compact mass with a bulk density, which is assumed to be known. Furthermore, these models do not provide a detailed insight into the transport processes and therefore complicate a systematic optimization. For these reasons, the feed section in this work will be simulated applying the discrete element method (DEM) with use of the open source software LIGGGHTS®. The DEM allows a three-dimensional treatment of the feed section and considers each single particle. Overall this work is focusing on two cases. In case of a conventional extruder with an open discharge, which conveys the plastic particles without melting them, the measured mass flows are reproduced exactly. Under real operating condition... |
