Influence of Graphitization Conditions at 3000°C on Structural and Mechanical Properties of High-Modulus Polyacrylonitrile-Based Carbon Fibers

Autor: D. B. Verbets, E. I. Timoshchuk, V. M. Samoilov, N. N. Steparyova, D. V. Ponomareva, A. V. Nikolaeva, I. A. Bubnenkov, E. A. Danilov
Rok vydání: 2018
Předmět:
Zdroj: Inorganic Materials: Applied Research. 9:890-899
ISSN: 2075-115X
2075-1133
DOI: 10.1134/s2075113318050258
Popis: The effect of the graphitization conditions at 3000°C on the crystal structure and properties of high-modulus polyacrylonitrile-based carbon fibers (CFs) is studied. It is shown that an increase in the temperature of CF processing from 1400 to 3000°C leads to a decrease in the tensile strength and an increase in Young’s modulus. However, an increase in the winding rate from 10 to 300 m/h during the synthesis of CFs at a fixed graphitization temperature of 3000°C leads to decreases in both the tensile strength and Young’s modulus. The crystal structure of the synthesized CFs is studied by the X-ray diffraction and Raman spectroscopy methods. It is shown that an increase in the thermal processing temperature from 1400 to 3000°C leads to a decrease in the d002 interlayer spacing and an increase in the crystallite size Lc. It is established by the Raman spectroscopy method that the ID/IG parameter (the ratio of the integral intensities of the D and G spectral bands) decreases at the same time, which is also characteristic of an increase in the degree of perfection of the CF crystal structure. On the contrary, an insignificant increase in the d002 interlayer spacing and a decrease in the Lc value are observed with an increase in the winding rate for CFs synthesized at a fixed graphitization temperature of 3000°C, while the ID/IG parameter in this case hardly changes. A detailed analysis of the shape of the (002) diffraction peak shows that, unlike CFs obtained at a winding rate of 10 m/h, CFs obtained at higher winding rates consist of at least two distinct structures of different degrees of graphitization. Further thermal treatment of these CFs at 2650°C under steady-state conditions leads to a significant decrease in the d002 spacing parameter and an increase in the Lc value. It is established from the measurements of the ID/IG ratio that radial inhomogeneity of the CF crystal structure over the cross section increases at higher winding rates, which is associated with inhomogeneous heat transfer in the filaments. It is concluded that high rates of heating to 3000°C have a negative effect on the structural and mechanical properties of CFs.
Databáze: OpenAIRE
Externí odkaz: